MSDS

HANDLING AND STORAGE
7
Use in accordance with good industrial workplace practices. Avoid unnecessary contact.
Wash thoroughly after handling. Use with good ventilation.
Handling Precautions:
Store in a dry place away from excessive heat. Store containers with lids on and properly
labeled.
Do not store at temperatures above 120 degrees F.
Storage Requirements:
EXPOSURE CONTROLS/PERSONAL PROTECTION
8
Eye wash stations and emergency showers should be immediately available.
Engineering Controls:
Eyes and Face: Standard safety glasses with splash shields typically offer adequate
protection. Where excessive splashing or spraying is possible, a face shield should be
used. Do not wear contacts.
Skin and clothing: Excessive contact should be avoided. Nitrile gloves, boots and
aprons will provide adequate protection when contact cannot be avoided. Remove and
wash any contaminated clothing immediately. Wash thoroughly after handling.
Respiratory: Good general ventilation should be sufficient to control airborne levels.
Maintain airborne concentrations below OSHA established exposure limits of
ingredients in Section 2. Use NIOSH approved respirator if ventilation is not adequate
enough to maintain levels below these limits.
Protective Equipment:
The Blaster Chemical Companies takes no responsibility for determining what
measures are required for personal protection in any specific application. This
information should be used with discretion.
Exposure Guidelines/Other:
PHYSICAL AND CHEMICAL PROPERTIES
9
milky whiteAppearance:
liquidPhysical State:
strong aromaticOdor:
Not DeterminedpH:
5.6 psi @ 110FVapor Pressure:
~3 (air=1)Vapor Density:
145 - 157 FBoiling Point:
Not DeterminedFreezing/Melting Pt.:
NilSolubility:
0.678 @ 60FSpec Grav./Density:
Not Determined
Not Determined
8.10 (nBuAc=1)
Not Determined
Not Determined
Not Determined
Not Appicable
Not Appicable
Not Determined
Not Determined
Not Determined
Not Determined
Heat Value:
VOC:
Evap. Rate:
Bulk Density:
Octanol:
Molecular Weight:
Particle Size:
Softening Point:
Viscosity:
Percent Volatile:
Sat. Vap. Concentrat.:
Molecular Formula:
TDL - The Dry Lube
Material Safety Data Sheet
Revision Date: 03/18/09MSDS Number: TDL - aerosol
Page of
3 6
MSDS
The Blaster Corporation