Technical data

Operating Manual BDC 1216
Safety advice
The Operating Instructions must be supplemented by instructions
including the duty to supervise and report relating to particular
working practices, for example work organisation, work procedures
and personnel allocation.
Personnel entrusted with working with the dust collector must
have read the Operating Instructions before starting work, in
particular the Safety Instructions chapter. To read these instructions
during work is too late. This particularly applies to incidental activities
such as setting up the equipment, carrying out maintenance work or
training staff to work with the dust collector.
From time to time the working practices of the staff are to be checked
regarding awareness of safety and hazards.
Personnel must tie back long hair and not wear loose clothing or
jewellery including rings. There is a risk of injury through getting stuck
or being drawn into moving machinery.
Use personnel protection equipment if necessary or required by
regulations! Take notice of all safety and hazard notices on the
dust collector!
All safety and hazard notices at or on the dust collector must be
kept complete and legible!
If safety-critical changes occur to the dust collector or its working
method, the dust collector must be shut down immediately! The
cause of the fault must be established immediately!
Changes, add-ons or conversions to the dust collector which might
impair safety must not be undertaken without the manufacturer's
permission!
This applies in particular to the fitting and adjustment of safety
devices as well as to welding on load-bearing parts.
Spare parts must comply with the technical requirements specified by
the manufacturer. This is always guaranteed if original spare parts
are used.
Intervals for recurring checks and inspections specified in these
Operating Instructions must be complied with!
4