Operation Manual

ManualsBrandsBlaupunkt ManualsDomestic5B49M8160

Rails en

œ will flash on the display panel if the cooking

compartment has not yet cooled down completely. Wait

until the cooking compartment has cooled down and

the œ indicator has gone out.

An audible signal will sound once the cleaning cycle

has finished. ‹‹:‹‹ will appear on the display panel.

Switch off the oven using the main switch.

Subsequent cleaning

The remaining water in the cooking compartment must

be removed promptly. Do not leave the remaining water

in the cooking compartment for a long time (e.g.

overnight). The oven must not be operated while the

cooking compartment is still wet or damp.

1. Open the appliance door and remove the remaining

water with an absorbent sponge cloth (fig. ").

2. Clean the smooth surfaces in the cooking

compartment with a dish cloth or a soft brush.

Remove stubborn food remnants using a stainless

steel scouring pad.

3. Remove limescale deposits with a cloth soaked in

vinegar. Then wipe with clean water and rub dry with

a soft cloth (including under the door seal).

4. Leave the appliance door ajar in the stop position

(approx. 30°) for approx. 1 hour to allow the enamel

surfaces in the cooking compartment to dry

thoroughly. Alternatively, you can also run the rapid

drying function for the cooking compartment.

Running the rapid drying function for the cooking

compartment

1. Once the cleaning assistant has finished, open the

appliance door as far as the stop position (approx.

30°).

2. Set 3D hot air to 50 °C.

3. After 5 minutes, switch off the oven and close the

appliance door.

Removing heavy deposits of dirt

You have several options for removing particularly

stubborn deposits of dirt.

■ Leave the soapy water in place for a while before

starting the cleaning assistant.

■ Rub soapy water onto the dirty areas of the smooth

surfaces before starting the cleaning assistant.

■ Run the cleaning assistant function again once the

cooking compartment has cooled down.

pRails

Ra i l s

With good care and cleaning, your appliance will retain

its appearance and remain fully functional for a long

time to come. This will tell you how to remove the

shelves and clean them.

Detaching and refitting the rails

:Warning – Risk of burns!

The rails become very hot. Never touch the hot rails.

Always allow the appliance to cool down. Keep children

away from the appliance.

Detaching the rails

1. Lift the rail slightly at the front ‚ and detach it ƒ

(figure !).

2. Then pull the whole rail towards you and take it out

(figure

").

Clean the rails with cleaning agent and a sponge. For

stubborn deposits of dirt, use a brush.

Attaching the rails

The rails only fit on the right or the left side. The pull-out

rails must pull out towards you.

1. First, insert the rail in the middle of the rear socket ‚,

until the rail rests against the cooking compartment

wall, and push it back ƒ (figure !).

2. Then insert the rail into the front socket „, until the

rail also rests against the cooking compartment wall

here, and press it downwards … (figure ").