Operation Manual
Table Of Contents
- 8 Intended use
- Intended use
- ( Safety instructions
- Delivery
- 1. Check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier.
- 2. Please dispose of the packaging material in an environmentally friendly manner.
- 3. Do not let children play with packaging and its parts. There is a risk of suffocation from collapsible boxes and film.
- Installation
- In daily use
- Childproof lock (door lock)Door lock *
- Damage
- Disposal
- 1. Make redundant appliances unusable to prevent subsequent accidents.
- 2. Dispose of the appliance in a n environmentally friendly manner.
- m Warning
- Risk of injury!
- ■ To prevent injuries, e.g. caused by stumbling, open the dishwasher only briefly in order to load and unload the dishwasher.
- ■ Knives and other utensils with sharp points must be placed in the cutlery basket with the points downwards or horizontally on the knife shelf*.
- ■ Do not lean or sit on the open door.
- ■ In the case of free-standing appliances, ensure that the baskets are not overloaded.
- ■ If the appliance is not in a cavity and a side panel is accessible, the door hinge area must be covered at the side for reasons of safety (risk of injury). The covers are available as optional accessories from customer service or specialist outlets.
- ■ If fitted, use the childproof lock. An exact description can be found in the back of the enve lope.
- ■ Do not allow children to play with or operate the appliance.
- ■ Keep children away from detergents and rinse aid. These may cause chemical burns in the mouth, throat and eyes or asphyxiation.
- ■ Keep children away from open dishwasher. The water in the rinsing compartment is not drinking water and could contain detergent residue.
- ■ Ensure that children do not place fingers in the tablet collecting tray 12. Small fingers could become caught in the slots.
- ■ When opening and closing the door on an eye-level appliance, ensure that children do not become jammed or crushed between the appliance door and the cupboard door below.
- ■ Children could become locked in the appliance (danger of suffocation) or get into another dangerous situation.
- 7 Protection of the environment
- * Getting to know your appliance
- + Water softening system/Special salt
- Water softening system/Special salt
- Setting
- 1. Find out about the hardness value of your tap water. Your water utility company will help you with this.
- 2. Setting can be found in the water hardness table.
- 3. Open the door.
- 4. Switch on ON/OFF switch (.
- 5. Hold down button > P and press START button h until the dry display ` and salt refill indicator )* flash.
- 6. Release buttons.
- To change the setting:
- Water hardness table
- Using special salt
- Using detergents with salt componentDetergents with salt component
- Switching off water softening systemSwitching off salt refill indicator/water softening system
- , Rinse aid
- Rinse aid
- Setting amount of rinse aid
- Switching off rinse-aid refill indicator
- - Utensils
- Utensils
- Not suitable
- Glass and utensil damage
- Loading the dishwasher
- Unloading the dishwasher
- Cups and glasses
- Pans
- Cutlery basket
- EtagereEtagere *
- Folding spikesFolding spikes *
- Small accessories holder *Small accessories holder
- Knife shelf *Knife shelf
- Adjusting the height of the basketAdjusting the height of the basket *
- Top basket with side levers
- 1. Pull out the top basket 1" out.
- 2. To lower the basket, press in the left and then the right lever on the outside of the basket. In doing so, hold the sides of the basket along the upper edge to prevent it from suddenly dropping.
- 3. To raise the basket, hold the basket on the sides of the upper edge and lift it up.
- 4. Before re-inserting the basket again, ensure that it is at the same height on both sides. Otherwise, the appliance door cannot be closed and the upper spray arm will not be connected to the water circuit.
- Top basket with upper and lower roller pairs
- . Detergent
- / Overview of programmes
- Overview of programmes
- The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
- Programme selection
- Information for test institutes
- 0 Additional options
- 1 Operating the appliance
- Operating the appliance
- Programme data
- Aqua sensorAqua sensor *
- Switching on the appliance
- Optical display while the programme is runningOptical display while the programme is running *
- Timer programmingTimer programming *
- 1. Switch on ON/OFF switch (.
- 2. Keep pressing the Preselected starting time button 0 until the appropriate display 3h, 6h or 9h is lit.
- 3. Press START button h, timer programming is activated.
- 4. To delete the preselected starting time, keep pressing the Preselected starting time button 0 until none of the displays 3h, 6h or 9h is lit.
- End of programme
- 1. Open the door.
- 2. Switch on ON/OFF switch (.
- 3. Hold down button > P and press START button h until the dry display ` and salt refill indicator )* flash.
- 4. Release buttons.
- 5. Keep pressing button > P until the salt refill indicator )* and rinse aid refill indicator )" flash.
- 6. Release buttons.
- To change the setting:
- Note
- Interrupting the programme
- Terminating the programmeTerminating the programme (Reset)
- Changing the programme
- Intensive drying
- 1. Open the door.
- 2. Switch on ON/OFF switch (.
- 3. Hold down button > P and press START button h until the dry display ` and salt refill indicator )* flash.
- 4. Release buttons.
- 5. Keep pressing button > P until the salt refill indicator )* and “Check water supply” )2 flash.
- 6. Release buttons.
- To change the setting:
- 2 Cleaning and maintenance
- Cleaning and maintenance
- Overall condition of the machine
- Special salt and rinse aid
- Filters
- 1. After each washing cycle check the filters for residue.
- 2. Unscrew filter cylinder as illustrated and take out filter system.
- 3. Remove any residue and clean filters under running water.
- 4. Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system.
- Spray arms
- 3 Fault, what to do?
- Fault, what to do?
- Note
- Waste water pump
- m Warning
- Risk of cuts!
- 1. First always disconnect the appliance from the power supply.
- 2. Take out top basket 1" and bottom basket 1b.
- 3. Remove the filters 1R.
- 4. Scoop out water, use a sponge if required.
- 5. Prise out the white pump cover (as illustrated) using a spoon. Grip the cover on the crosspiece and lift diagonally inwards. Remove cover completely.
- 6. Check impeller wheel and remove any foreign objects.
- 7. Place cover in the original position and press down until it engages (click).
- 8. Install filters.
- 9. Re-insert baskets.
- Risk of cuts!
- Fault table
- m Warning
- 4 Customer service
- 5 Installation and connection
- Installation and connection
- Product package
- Safety instructions
- Delivery
- Technical specifications
- Installation
- Waste-water connection
- Drinking water connection
- Electrical connection
- Removing the appliance
- Transportation
- Drain the appliance according to the following steps:
- 1. Turn on the tap.
- 2. Open the door.
- 3. Switch on ON/OFF switch (.
- 4. Select programme @ with the highest temperature button < H.
- 5. Press START button h.
- 6. Close the door.
- 7. Open door after approx. 4 minutes.
- 8. Press START button h for approx. 3 sec.
- 9. Close the door.
- 10. Switch off ON/OFF switch (.
- 11. Turn off the tap, disconnect supply hose and drain water.
- Drain the appliance according to the following steps:
- Protection against frostProtection against frost (Emptying the appliance)
Detergent en
17
. Detergent
Detergent
You can use tablets as well as powder
or liquid detergents for dishwashers, but
never use washing up liquid.
The dosage can be individually adjusted
with powder or a liquid detergent
according to the degree of soiling.
Tablets contain an adequately large
amount of active ingredients
for all cleaning tasks. Modern, powerful
detergents predominantly use a low-
alkaline formulation with phosphate
and enzymes. Phosphates bond
the lime in the water. Enzymes break
down starch and remove protein.
Phosphate-free detergents are less
frequent. These have a slightly weaker
lime bonding capacity and require
a higher dosage. To remove coloured
stains (e.g. tea, tomato sauce), oxygen-
based bleaching agents are usually
used.
Note
To ensure a good washing result,
always follow the instructions
on the detergent packaging!
If you have further questions,
we recommend that you contact
the detergent manufacturers’ helpline.
ã Warning – Read and observe the
safety information and instructions for
use on the packaging for cleaning and
rinsing agents.
Adding detergent
1. If the detergent dispenser 9" is still
closed, press the lock 9* to open
the detergent dispenser.
Pour detergent into the dry detergent
dispenser 9" only (insert tablet flat,
not on its edge).
Dosage: see manufacturer’s
instructions on the packaging.
The graduated detergent
dispenser 9" helps you add the
correct amount of powder or liquid
detergent.
Usually 20 ml–25 ml are adequate
for normal soiling. If using tablets,
one tablet is adequate.
2. Close the cover on the detergent
dispenser by sliding it up until the
lock engages without difficulty.
The detergent dispenser opens
automatically at the optimum time
depending on the programme.
The powder or liquid detergent
is distributed in the appliance and is
dissolved, the tablet falls into
the tablet collecting tray where it
dissolves in doses.
PO
PO
PO