Operating Instructions ACD 9430 ACD 9430 76 42 757 013 3 D92 162 036
QuickOut a 1 2 3 1 4 5 6 7 8 9 10 2 Radio a b h g c b QuickOut 3 CD d 9 j i 9 f e 3 ACD 9430 76 42 757 013 3 D92 162 036
Front Panel Description 1 ON/OFF Switch on the set by turning knob 1. 2 AUD button (sound control/broader interior sound impression) BAS – Adjustment of the low frequencies via buttons 7. TRE – Adjustment of the high frequencies via buttons 7. BAL – Adjustment of the left/right volume via buttons 7. FAD – Adjustment of the front/rear volume via buttons 7.
Wrong code number entered ................ 14 Switching the code system on .............. 14 Restart following interruption of power supply .................................................... 15 Switching the code system off .............. 15 Amplifier Section .......................... 15 ON/OFF ................................................ 15 Bass and Treble Control ....................... 15 Balance and Fader Control ................... 16 Inserting the Disc ..................................
Anti-theft coding To listen to the radio or cassette again, • insert the set into the compartment until it stops and move the handle back to the front panel. If the coding system is off, your set will be ready for operation. If the coding system is on, proceed as described under “Restart following interruption of power supply”. The car radio comes standard with the code system deactivated. If the anti-theft coding system is on while the power supply to the unit is interrupted (e.g.
• Your car radio is now ready for operation. If three dashes appear again in the display, you have entered a wrong code number. ENGLISH Enter the code number given in the Blaupunkt car radio passport: Preset button 1 only allows to choose “0” or “1”. The first “0” will not be displayed. Example: the code number is 0521. - Press preset button 1 until “000” appears in the display. - Press preset button 2 five times, “500” appears in the display. - Press preset button 3 twice, “520” appears in the display.
Radio Section Balance and Fader Control Selecting a Station Balance control To balance the sound level left/right: • Press the AUD button 2 until bal is shown on the display. Press rocker switch 7 on the left or right to adjust the sound impression according to your personal preferences. Display 9 gives you a number between -9 and +9. With your car radio you can select stations from the FM (ultra-short wave) and FM-Travelstore level.
Automatically Storing the Strongest Stations (Travelstore) With Travelstore, you have the opportunity to automatically store the 5 strongest FM stations of your respective area and have them Activating a Stored Station If required, the memorized stations can be activated at a keystroke. • For this, choose the FM or T storage level and briefly • press the respective preset button :. Traffic Messages (ARI) Many FM stations broadcast local traffic messages at regular intervals.
CD Section Now press the ARI button 4. The ARI indication lights up on display 9 c. • • Then tune in to one of the traffic stations of your area. Switch over to CD operation by either • inserting a disk, or - if a CD is already inserted by • pressing the SRC button 6. CD reproduction will be interrupted as soon as a traffic message is “put through”. When leaving the coverage area of the tuned in traffic station, your car stereo will automatically start searching for a new one.
Appendix The car radio’s DSC function (Direct Software Control) allows you to adjust the seek tuning sensitivity for FM and the volume of ARI traffic messages. Technical Data Use the rocker switch < > 7 to adjust the volume of traffic messages 1 =^ low volume 9 =^ high volume To store the adjustment, • press the ARI button once again.
