Operation Instructions ACD 9431 ACD 9431 76 42 758 013 3 D92 147 037
1 2 3 1 4 5 6 7 8 QuickOut a 9 10 2 Radio a b c h g b QuickOut 3 CD d 9 j i 9 f e 3 ACD 9431 76 42 758 013 3 D92 147 037
Front Panel Description 1 ON/OFF Switch on the set by turning knob 1. 2 AUD button (sound control/broader interior sound impression) BAS – Adjustment of the low frequencies via buttons < > 7. TRE – Adjustment of the high frequencies via buttons < > 7. BAL – Adjustment of the left/right volume via buttons < > 7. FAD – Adjustment of the front/rear volume via buttons < > 7.
Front Panel Description ............... 12 CD Section .................................... 17 What you need to know! Important information .................. 13 Inserting the Disc .................................. 17 Ejecting the Disc ................................... 17 Title Selection/Cueing and Reviewing .. 17 Mix Function .......................................... 18 Changing the Audio Source with SRC ..
Anti-theft coding To listen to the radio or cassette again, • insert the set into the compartment until it stops and move the handle back to the front panel. If the coding system is off, your set will be ready for operation. If the coding system is on, proceed as described under “Restart following interruption of power supply”. The car radio comes standard with the code system deactivated. If the anti-theft coding system is on while the power supply to the unit is interrupted (e.g.
• Your car radio is now ready for operation. If three dashes appear again in the display, you have entered a wrong code number. ENGLISH Enter the code number given in the Blaupunkt car radio passport: Preset button 1 only allows to choose “0” or “1”. The first “0” will not be displayed. Example: the code number is 0521. - Press preset button 1 until “000” appears in the display. - Press preset button 2 five times, “500” appears in the display. - Press preset button 3 twice, “520” appears in the display.
Radio Section Balance and Fader Control Selecting the Desired Waveband Balance control To balance the sound level left/right: • Press the AUD button 2 until bal is shown on the display. Press rocker switch < > 7 on the left or right to adjust the sound impression according to your personal preferences. Display 9 gives you a number between -9 and +9. With this set you have free choice from the following wavebands: FM (ultra-short wave; frequency-modulated), MW (medium wave), and LW (long wave).
Note: If you tune to an FM station already stored on the storing levels FM or Travelstore, the coresponding storing level and the preset button will flash in the display. Activating a Stored Station If required, the memorized stations can be activated at a keystroke. • For this, choose the FM or T storage level and briefly • press the respective preset button :. Ejecting the Disk • To eject the disk, keep the • SRC button 6 depressed for at least 2 seconds.
Programming with DSC Appendix Review (Fast backward): • Keep depressed the left side of the rocker switch < > 7 for more than than 1 second. The car radio’s DSC function (Direct Software Control) allows you to individually adjust the seek tuning sensitivity for FM and AM. Technical Data Mix Function Adjusting the seek tuning sensitivity: • Press the lo•m 5 button longer than 8 secs. The display gives you “lo” and a number between 1 and 3.
