Operating instructions

B 9e

FM operation

1.Press the STANDBY BUTTON to power on, the unit will switch to FM mode as first priority.

The FM station information will show on display.

2.Long press the “ Button” for 2-3 seconds, the radio can upward full- scan the station.

The frequency will stop and play the scanned station automatically once they get the

signal. Press again to continue. Press the “ Button” briefly to adjust the radio frequency

step by step.

3.Long press the “  Button” for 2-3 seconds, the radio can downward full- scan the

station. The frequency will stop and play the scanned station automatically once they get

the signal. Press again to continue. Press the “ Button” briefly to adjust the radio

frequency step by step.

4.During FM reception, please make sure keep the FM TELESCOPIC ANTENNA fully

extended always for best performance. However, if FM reception is weak, try

repositioning the unit near to open window until you get the better signal reception.

5.Press the “VOL+” or “VOL-“ to adjust the volume up and down

6.Press the STANDBY BUTTON to power off

7.Preset Radio station

Press the Button or button to select desired radio frequency, then press ”MEMORY”

button; press ”PRE-DN” and ”PRE-UP” to browse you supposed pre-set station number,

then press the ”MEMORY” button again for confirmation.

We can memory 30 Radio stations totally

CD operation

NOTE:

This unit not only plays commercial compact discs but also complied CD-RW discs.

• Because of non-standardized format definition/production of CD-R/RW, playback

quality & performance is not guaranteed.

• Manufacturer is not responsible for the playability of CD-R/RW due to recording

conditions such as PC performance, writing software, media properties etc.

• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a

malfunction.

Play mode

1. Press the FUNCTION BUTTON switch to the “CD” mode.

2. Push and open the CD DOOR, load a CD and make sure the coating side of CD face to

upward and then close the CD door.

3. The unit will display “CD READ” ,and read the disc information

4. After read out the total number of tracks, the unit will play the CD automatically!

5. Press the “ Button”, the CD will play the previous track, press the “ Button”, the CD

will play the next track, press PLAY/PAUSE BUTTON for play and pause playing ,press again

to resume.

6. Press the “VOL+” or “VOL-“ to adjust the volume