User manual

User manual BDR-500 / BDR-501
7
Connecting power
Connect an AC adapter (not supplied) to the DC IN 6V jack of the unit and to the mains socket.
Caution!

e power lead in a safe manner and make sure it is not subjected to
trapping or pinching. If the power lead is damaged refer to a qualified service agent.
y disconnected the
power input, the AC adaptor shall be disconnected from the mains completely. The AC adaptor should not be obstructed
or should be easily accessed during intended use.
Battery operation
1. Remove the lid of the battery compartment by sliding it outward in the direction of the arrow.
2. Insert 4 R6/UM3/AA batteries into the compartment. Make sure to match their polarities (+/-) to the markings inside the
compartment.
3. Replace the lid.
Notes on batteries (not supplied)
ent types of batteries or old batteries with new ones.



 should be drawn to the environmental aspects of battery disposal.

 eplace them with new batteries.


them back for specific recycling.
Caution!
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
SETTING TIME

1. Press MEMO once to enter time s / to
select 24H or 12H time format.
2. Press MEMO again to confirm and the hour digits flash.
3. Press tuning / to set the hour value. Press MEMO to confirm and minute digits flash.
4. Press tuning / to set the minute value and press MEMO again to confirm.
SETTING THE ALARM
Set alarm time
2. In Standby mode, long press ALARM 
2. Press tuning / to adjust hour value. Then press ALARM to confirm and minute digits flash.
3. Press tuning / to adjust minute value and press ALARM to confirm.
Set wake up source
Press ALARM   
SOUND
displays and buzzer sound will come out when the alarm time is reached.

3. 
4. displays and radio sound will come out when the alarm time is reached.
Checking Wake Time
Long press ALARM until you see a flashing wake time.
Silence the alarm momentarily
Press SNOOZE to turn the alarm off temporarily. The alarm will sound again when the snooze period is over.
BLAUPUKT TECH SA