Operation Manual

28
Rear Seat Entertainment (RSE)
The device features audio and video outputs for the rear
area of the vehicle to which two external monitors and
headphones, e.g. via suitable jacks, can be connected.
The following sources are available for the Rear Seat
Entertainment:
• Disc
• USB RSE (rear side)
• A/V In 1
• A/V In 2
쏅 Select the desired source in the main menu and start
playback.
쏅 In the main menu (if necessary under Apps), select
the Rear Zone app.
쏅 Under Rear Zone, select the previously started source.
The playback now also takes place in the rear area
of the vehicle.
Note:
During the RSE playback, you can select a di erent
source for the front area of the vehicle in the main
menu. The RSE playback of the originally selected
source continues unimpeded.
쏅 To exit the RSE, select the Rear Zone app again and
tap on Rear O .
Showing device display on
external monitor
If the installation position of the device is not optimal for
viewing displays (e.g. for using the navigation), you can
output the device display on an external monitor.
쏅 In the main menu (if necessary under Apps), select
the Rear Zone app.
To switch the playback on an external monitor on or o ,
쏅 tap on Front Display.
Note:
As long as the playback on an external monitor is
switched on, you cannot use the Rear Seat Entertain-
ment.
Steering wheel-mounted controls
(SWC)
Up to 8 functions of the device can be operated via
existing steering wheel-mounted controls. This requires
assigning the desired functions to the buttons of the
steering wheel-mounted controls.
Note:
The SWC function operates with analogue control
signals (passive resistive matrix). Depending on the
vehicle type, you may require an additional interface.
쏅 In the main menu (if necessary under Apps), select
the SWC app.
In the  rst step, assign the desired functions to up to 8
placeholders:
쏅 Select one of the placeholders 1 - 8.
쏅 Select a function for this placeholder.
An assigned placeholder is identi ed by a check
mark. A selected function is identi ed by the number
of the placeholder.
쏅 Repeat these steps for every additional function to
be assigned to the steering wheel-mounted controls.
In the next step, assign the assigned placeholders to the
buttons of the steering wheel-mounted controls:
쏅 Tap on [
].
Placeholder 1 and the assigned function are
displayed.
쏅 Press a button of the remote control for approx. 1
second.
The displayed function is assigned to the button
being pressed.
쏅 Tap on [
] to assign the next function.
Note:
Tap on [
] to return to a previous function and, if
necessary to reassign it.
Rear Seat Entertainment | Showing device display on external monitor | Steering wheel-mounted controls