Operation Manual

10
Home Automation Setting (Optional
Power Switch required)
The Home Automation Setting enables you to
program Power Switches to turn on/off for set
duration according to different conditions
The follow conditions are available for setting:
Arm – When the system is Away Armed.
Home – When the system is Home Armed.
Disarm – When the system is Disarmed.
High Temperature – When the temperature is
higher than the pre-set threshold.
Low Temperature – When the temperature is
lower than the pre-set threshold.
Time – When the system reaches set time.
(Not Available for SA2500)
Alarm Event – When the set alarm event is
triggered.
 Select the condition.
 Select to enable/disable the rule.
 Select the Power Switch channel to be
controlled.
 Choose to turn on or off the Power Switch.
 Select the duration of on/off status.
 For High/Low Temperature condition, set
the temperature threshold for the Power
Switch to be activated/deactivated.
 For Time condition, set the time when the
Power Switch should be activated/
deactivated.
 For Alarm Event condition, set the events
for the Power Switch to be
activated/deactivated, you can set more
than one events
 Press “Save”. The phone will send a SMS
command to panel to program the Home
Automation setting.
<NOTE>
 For system mode change (Arm,
Home, Disarm), the Power Switch
channel selection is limited to #1
only.
 For High/Low Temperature and
Time setting. You can select any
Power Switch channel from #1 ~ #4
 High/Low temperature setting in
Home Automation does not affect
High/Low temperature report
setting.