Operation Manual

19
 Capture Image (SH3000 only)
SH3000 panel can be controlled remotely via
SMS command to take a picture with its PIR
Camera. The picture will be uploaded
according to the Control Panel setting.
 Enter the.zone number of your PIR Camera,
then press “Save” to send the SMS
command.
Home Automation Setting (Optional
Power Switch required)
The Home Automation Setting enables you to
program Power Switches to turn on/off for set
duration according to different conditions
The follow conditions are available for setting:
Arm – When the system is Away Armed.
Home – When the system is Home Armed.
Disarm – When the system is Disarmed.
High Temperature – When the temperature is
higher than the pre-set threshold.
Low Temperature – When the temperature is
lower than the pre-set threshold.
Time – When the system reaches set time.
(Not Available for SA2500)
Alarm Event – When the set alarm event is
triggered.
 Press the top column to select the
condition.
 Select to enable/disable the rule.
 Select the Power Switch channel to be
controlled.
 Choose to turn on or off the Power Switch.
 Select the duration of on/off status.