Operation Manual

CRP8BK / CRP8WH

INSTALLATION

Plug the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the back

of the unit. Your clock radio is ready to work for you.

BACKUP BATTERY INSTALLATION

Your clock radio requires one CR2032 lithium battery (not included) to provide backup

power to the clock in the event of a temporary power interruption.

1. Place your unit face down on a flat surface.

2. Slide and remove the battery cover at the bottom of your unit.

3. Insert one new CR2032 lithium battery into the battery compartment with the “+” side

facing up as indicated.

4. Replace the battery cover.

If AC power is interrupted, the LED display will go off and both the radio and the alarm

will not function. The backup battery will keep the time and all settings of your unit.

Make sure a fresh CR2032 lithium battery is used. A fresh CR2032 battery could backup

your clock continuously.

SETTING TIME, 12/24HR TIME AND THE SNOOZE DURATION

1. Press SET once, the hour digits flash. Press Ʒ or ͩ to set the current hour (hold to

advance rapidly).

2. Press SET again, the minute digits flash. Press Ʒ or ͩ to set minutes.

3. Press SET again, the display shows “24H” and flashes, press Ʒ or ͩ to select “12H” or

“24H” time format.

4. Press SET again, the display shows “05” and flashes, press Ʒ or ͩ to select your snooze

time from 5 to 60 minutes.

5. Press SET again or if no key pressed for approx. 10 seconds to exit the setting mode.

Note: when 12-hour time format is selected, the P (PM) icon will appear on the lower

middle time display to indicate the afternoon time; there is no AM indicator.

SETTING THE ALARMS

1. Press AL 1.2 once, the 1 icon and the hour digits flash. Press Ʒ or ͩ to set the alarm 1

hours.

2. Press AL 1.2 again to adjust minutes. Press Ʒ or ͩ to set the alarm 1 minutes.

3. Press AL 1.2 again, LED displays “OFF” (alarm off). To select wake to sound sources, press

Ʒ or ͩ to select :-

rd = wake-by-radio

bu = wake-by-buzzer

OFF = alarm off

4. Press AL 1.2 again, the 2 icon and the hour digits flash. Press Ʒ or ͩ to set the alarm 2

hours.

5. Repeat step 2) and 3) to set alarm 2.

6. Press AL1.2 again or no button around 10 seconds to exit alarm setting mode. When

wake-to-radio or wake-to-buzzer is selected, the related alarm is turned on, indicated by

appearance of the 1 and / or the 2 icon on the left side of the display.

ENGLISH