Operating instructions

103

INTRODUCTION NAVIGATION RADIO MODE CD MODE INDEXSETUPCD CHANGER

ENGLISH

DEUTSCH

7 Use the right knob/pushbutton ; to select START.

8 Carry out the steps as instructed by the system.

Carrying out the system test

You have the option of carrying out a system test. The system checks the GPS

antenna and whether the reversing signal and the vehicle ignition are correctly

connected to the system.

1 Select SYSTEM TEST menu item in the INSTALLATION setup menu.

2 Press the right knob/pushbutton ;.

3 Choose between SENSOR TEST, INTERNAL TEST and CALIBRAT. DATA.

✔ The displays containing the corresponding test results are shown.

Activating / deactivating the code feature

You can activate your TravelPilot’s code feature in the SAFETY setup menu. If

the code feature is activated and the unit was disconnected from the battery

power supply, you can only operate the unit again once you have entered a

code number.

Note: Since the TravelPilot is not equipped with any other theft pro-

tection system, you should activate the code feature.

To activate / deactivate the code feature,

1 highlight the CODE menu item in the SAFETY setup menu and

2 press the right knob/pushbutton ;.

The code feature is activated / deactivated. The current status is displayed along-

side CODE. You have to respond to the confirmation request by entering the

code. The default setting is OFF, i.e. the code is not activated.

SETTINGS

INSTALL

DEFAULT SET.

FM-SEEK SENS

SAFETY

LANGUAGE

INSTALLATION

SYSTEM TEST

CALIBRATION

GPS STATUS