Operating instructions

234
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
Calibration after a tyre change
It may be necessary to recalibrate the TravelPilot after a tyre change.
1 Select TYRE CHaNGE from the installation menu.
2 Please drive along a route of between 4 and 10 miles with good GPS
reception.
✔ The system carries out the calibration automatically.
Manually calibrating the system
You can also manually calibrate the system. You will be required to drive a route
of at least 350 feet at a maximum speed of 19 mph. Please note that a route
must be used that has been measured as precisely as possible.
1 Select MANual CALIBration from the installation menu.
✔ You will now be asked to enter the length of the route that you want to
drive.
2 Set the route length using the
or button :.
3 Press the OK button ;.
✔ You will be asked to drive the route.
4 Press the OK button ;.
5 Carry out the operating steps as instructed by the system.
NAV
INSTALL
NEW INSTLL
TYRE CHNGE
SYS TEST
MAN. CALIB
NAV
INSTALL
NEW INSTLL
TYRE CHNGE
SYS TEST
MAN. CALIB