Operation Manual

INSTALLATION AND CONNECTION
36
Installation and connection
Installation and safety notes
Please read the following information care-
fully before plugging in your IVOD-1022
DVD player.
The negative terminal on the battery must
be disconnected while the device is being
installed and connected.
Observe the safety notes from the vehicle
manufacturer (airbag, alarm systems, on-
board computer, immobiliser).
When installing the device, choose a place
to which the IVOD-1022 can be securely
screwed so that it does not hinder the driver
or endanger the vehicle occupants should
the vehicle come to an abrupt stop, e.g. in
the case of emergency braking.
Do not store the remote control in the
inflation range of the airbags, make sure
it is stored securely so as not to endanger
vehicle occupants in the event of an emer-
gency braking.
Do not install the IVOD-1022 in a place,
where it distracts the driver or restricts
his range of vision.
where it hinders getting into and getting
out of the vehicle.
so that the function of other vehicle com-
ponents is impaired (e.g. sunroof).
where it is subject to direct sunlight.
near hot air outlets (heating, etc.).
where it is subject to rain or moisture.
where it is subject to dust or dirt.
where it is subject to strong vib rations.
•
•
•
•
•
•
•
•
Installation of the monitor
Only use the mounting parts included.
Note the following when selecting a place
for installation:
No safety-relevant parts (fuel tank, cable,
etc.) of the vehicle may be damaged by
the screws.
Do not mount the device to the roof
interior lining only.
Use a solid base which is suitable for
supporting the woodscrews included.
Make sure that the device is installed in
a secure, solid place and that it cannot
come loose in the event of emergency
braking.
Avoid using the monitor over a long pe-
riod of time while the engine is not run-
ning to avoid draining the battery.
Fig. 1
Fig. 2
•
•
•
•
•
2.DVD_IVOD_gb.indd®.indd 36 24.11.2005 10:40:52 Uhr