Operation Manual

27
3 Information about the current route and position
Showing/hiding information
Note:
You can select the displayed information yourself
(see the section "Navigation settings", Settings for
visual instructions option).
4 Tapping on the map to determine a destination on
the map
Note:
For a planned route, you have the following options:
§ Replacing the existing destination with a new des-
tination.
§ Planning the new destination as interim destina-
tion of the route.
§ Planning the new destination as  nal destination
of the route.
5 Name of current street
6 Opening the navigation menu
Determining the destination on the map
21 3
4678 5
This map view features the following functions and
displays:
1 Toggling 2D/3D map view
2 Changing the map orientation
3 Displaying address and GPS information about the
current cursor position
4 For 3D map view only: Changing the tilt of the 3D
map view
5 Tapping on the map to reposition the cursor
6 Accepting the current cursor position as destination
7 Showing additional options:
§ Points of interest in the vicinity of the cursor
§ Save as favourite
§ Show cursor position
8 Zoom in/out
Navigation settings
The menu for navigation settings features the following
functions and settings:
¡ Audio and warnings: Settings for navigation an-
nouncements and warnings (e.g. of speed limits,
warning points such as sites of serious accidents and
school zones and referenced to tra c signs, e.g. for
curves and intersections)
¡ Customise quick access: De ning entries of the
quick access menu
¡ Managing driving times (truck version only): De n-
ing driving times and breaks as well as correspond-
ing noti cations
¡ Tra c: Adjusting TMC settings and use of earlier
tra c data (e.g. concerning tra c jams)
¡ Route Settings: Settings for the route planning (e.g.
type of vehicle, navigation mode, route planning
method and types of sections to avoid)
¡ User Pro les: Changing and renaming user pro le
¡ Note:
¡ The user pro le is based on your individual settings.
You can create up to four di erent pro les. When
changing to a di erent pro le, the application is re-
started. If this pro le has not been used previously,
the con guration wizard is called up at the start of
the application.
¡ Map Settings: General settings for the map view
¡ Settings for Visual Instructions: Settings for the
display of information in the map view
¡ Display: Settings for menu animations and daylight/
nighttime mode of the display
¡ Regional: Settings for the programme language as
well as units of measure and formats
¡ Trip Overview: Settings for storing trips and routes
¡ Protocol Storage: Settings for storing and transfer-
ring user and GPS data
¡ Con guration Wizard: Starting the con guration
wizard
¡ Reset to Default: Deleting individual settings and
restoring the factory settings
Navigation