Operating instructions

44
Scanning all of the cassette
tracks (SCAN)
➮ Press OK ; for longer than two
seconds.
“CAS SCAN” will appear in the display.
Scanning will begin with the next track
in ascending order.
➮ To stop the SCAN function, press
OK ; again.
The track currently scanned will contin-
ue playing.
Notes:
● It is possible to adjust the scan
time. For more information, read
the section on “Adjusting the scan
time” in the chapter on “Radio Op-
eration”.
● To be able to use the S-CPS, RPT
and SCAN functions, there has to
be a blank space of at least three
seconds between the tracks on the
cassette.
Switching the display mode
➮ To switch the display between the
tape side, counter, elapsed playing
time, remaining playing time and
the clock, press
/ DIS 7 for
longer than two seconds once or
repeatedly as required, until the de-
sired information appears in the
display.
Resetting the counter
To reset the counter,
➮ press 5 MIX >.
Fast forward/rewind
Fast forward
➮ Press :.
“FORWARD” will appear in the display.
Fast rewind
➮ Press :.
“REWIND” will appear in the display.
Stopping fast forward/rewind
➮ Press OK ;.
Playback will resume normally.
Note:
During fast forward/rewind, it is also
possible to listen to the last radio sta-
tion you tuned into. Switch on “Radio
monitor”.
Interrupting playback (Pause)
➮ To interrupt cassette playback,
press 3
>.
Playback will be interrupted, “CAS
PAUSE” will appear in the display.
➮ Press 3 > again to end the
pause.
Switching Radio monitor on/off
➮ Press MENU 8.
➮ Press : repeatedly until “RM
ON” or “RM OFF” appears in the
display.
➮ Press or : to switch Radio
monitor on or off.
➮ Press MENU 8 or OK ;.
TAPE DECK OPERATION