Operation Manual

10
Mounting in the vehicle | Switching on /off
Press the suction cup of the mounting against
the screen.
Fold the lever at the mounting plate toward
the screen.
Attach the cup retainer
The suction cup mounting plate has two supports
for the cup retainer.
Push the cup retainer onto the supports until
they engage.
Attach the device in the retainer
The device has two recesses on the lower surface
and a recess on the back for the retainer.
Place the device with the lower surface fi rst
on the retainer and press it to the rear.
The clamp support of the retainer must
engage audibly into the device back.
Align the mounting plate.
Removing the device
Press the clamp support downward.
The device is then detached from the
retainer.
Remove the device.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Removing the suction cup mounting
plate
If you change vehicles, you can remove the
mounting plate very simply.
Fold the lever at the mounting plate away from
the screen.
Remove the suction cup carefully at the edge
of the screen, so that air can come between it
and the screen.
Take the suction cup off carefully from the
screen.
Switching on /off
With the on/off switch you can turn the device on
or off as well as opening the main menu.
Switching on
Press the on/off switch for longer than 3
seconds.
Switching off
Press the on/off switch for longer than 3
seconds.
The device is then in stand-by mode and
remains ready for use. Only after 20 minutes
are all functions completely switched off.
Note:
Also in the switched off state the equipment
uses a small quantity of energy. If you use the
device again after a longer period, charging of
the battery may be necessary.
Reset
If the device does not function properly, a reset
may help.
Press the on/off switch for longer than 14
seconds.
The equipment is switched off and
automatically restarts.
쏅
쏅
쏅
쏅
쏅
쏅
TP100EE_lo_GB_193.indd 10TP100EE_lo_GB_193.indd 10 29.08.2008 13:31:25 Uhr29.08.2008 13:31:25 Uhr