TravelPilot Navigation Radio/CD TravelPilot DX-R52 / DX-R5 Installation instructions http://www.blaupunkt.
56 Installation instructions Safety instructions When carrying out installation work and making connections please observe the following safety instructions: - Disconnect the negative terminal of the battery! When doing so, please observe the vehicle manufacturer’s safety instructions. - Make sure you do not damage vehicle components when drilling any holes. - The cross sections of the positive and negative cables must not be less than 1.5 mm2.
. Installing the antenna Connect the antenna wiring to the enclosed bracket (see Fig. 5). 3.1 Radio antenna In pre-equipped vehicles (e.g.: VW, Seat, Audi), the antenna gets its power supply via the antenna wire (see the vehicle operating instructions). If you want to replace the OEM radio with a conventional radio, you will have to order an antenna supply diplexer (Order-No. 7 691 290 202) or the adapter cable (Order-No. 7 607 621 129) from your dealer.
258 4.4 Removing the TravelPilot Insert the handles into the corresponding holes on the left and right side of the front panel and push them in until you hear a loud click (unlocking the side spring locks). Use both handles to carefully pull the TravelPilot out of the compartment. Now you can pull out the connection cables by applying pressure on the side of the plug (see Fig. 7). Note: Once the handles have locked into place, they cannot be removed until you pull the TravelPilot out of the compartment.
RR R * Tel.-Mute (activ Low) Fig. 1 Fig. 4 4 Ohm 4 Ohm 4 Ohm 4 Ohm GPS antenna A Fig. 2 ENGLISH A 7 607 621 129 + + + + - PORTUGUÊS LR F LF ESPAÑOL A A 7 607 621 126 Radio antenna Fig. 3 Fig.
260 Fig. 6 –10 ° ° +30 Fig. 6a 90° 1. –10 ° ° +30 O.K. 2. 3. Fig. 7 –10° 2. 3. 90° Fig.
9 12 8 11 7 8 5 6 1 3 4 5 2 15 18 A 14 17 20 3 5 7 4 6 8 1 3 5 7 2 4 6 8 C 1 2 3 4 5 6 7 8 B A Gala/Tacho Tel.-Mute (active low) RFLS Permanent +12V Aut.
262 12V Relais Control cable (Power Antenna +) The control cable is the connected positive output for auxiliary components e.g.: power antennas, (maximum load < 150 mA). Important! Do not connect the control cable to terminal 15 (Plus connected) or terminal 30 (continuous plus). Wheel sensor (required for vehicles without a speedometer signal only) A Plus connection (connected to the ignition) terminal 15 +12V 8 604 390 045 This connection must be made via the ignition (terminal 15, +12V).
Country: Phone: Fax: www: http://www.blaupunkt.