Operation Manual

10
Installation in the vehicle | Switching on/off | Reset
Attaching the cradle
The suction cup holder features a mount for the
cradle.
Snap the cradle with the suction cup holder
into position.
Installing Lucca in the cradle
The Lucca features an opening on the underside
for mounting the cradle.
Remove the elastic cover from the underside
of the housing.
Place the Lucca on the mount of the cradle
and snap the Lucca to the rear and into posi-
tion.
Removing the Lucca
Press the lever of the cradle at the rear side of
the Lucca and pull the Lucca to the front.
Remove the Lucca to the top and out of the
cradle.
To protect the contacts, you can use the elas-
tic cover and dummy card again after using the
Lucca.
쏅
쏅
쏅
쏅
쏅
Switching on/off
Initial switch-on
During the initial switch-on of the Lucca, the soft-
ware is loaded into the system. For this reason,
the switch-on process
may last up to one minute.
The initial destination guidance also requires a
longer time than usual.
Switch-on
To switch on the Lucca, press the On/Off
switch below the display.
The Lucca is switched on. (If the device is in
the idle state, the previously active display is
shown again.)
Activating the idle state
To activate the idle state, briefl y press the On/
Off switch below the display.
The Lucca switches to the idle state.
Switching off
Press and hold the On/Off switch for longer
than 3 seconds to switch off the device.
The Lucca is switched off.
Note:
A complete switch-off of the Lucca is only nec-
essary if you do not operate the device for an
extended period of time or if you want to load
new map material from the SD/MMC card.
쏅
쏅
쏅
Reset
The Lucca can be restarted by using the Reset
button.
For this purpose, press the Reset button on
the underside of the Lucca.
쏅
Lucca_5_3_long_GB.indd 10Lucca_5_3_long_GB.indd 10 01.11.2007 14:11:48 Uhr01.11.2007 14:11:48 Uhr