Radio/Navigation TravelPilot RNS 3 Installation instructions
Installation instructions Safety information – – Faulty installation or servicing of this equipment may result in malfunctions in the vehicle’s electronic systems. To prevent damage to your TravelPilot, be sure to use the correct adapter cable to connect the vehicle 8-pin +/- ISO plug. Observe the following safety information while installing and connecting the system: – – – – – – Disconnect the negative terminal of the battery.
Installation instructions 4. Installing the TravelPilot 3. Installing the antenna Connect the antenna wiring to the enclosed bracket (see Fig. 5). 4.1 Setting the Gyro Important: Before the TravelPilot is inserted, the gyroscope must be put in a horizontal position (see Fig. 8). 3.1 Radio antenna In pre-equipped vehicles (e.g.: VW, Seat, Audi), the antenna gets its power supply via the antenna wire (see the vehicle operating instructions).
Installation instructions Note: Once the handles have locked into place, they cannot be removed until you pull the TravelPilot out of the compartment. 4.5 Connecting the back-up light signal wire The back-up light signal wire connects the system to the vehicle back-up light. Make sure that this connection is charged with 12 volts when the vehicle is reversing. Important: We assume no liability for faulty connections and their consequences! 4.
Installation instructions A A 7 607 621 126 F RR R * Tel.-Mute (active low) Fig. 1 R LF L + + + + - 4 Ohm 4 Ohm 4 Ohm 4 Ohm Fig. 4 7 607 621 129 A GPS antenna Bracket Fig. 2 1. Fig. 5 GPS antenna A Fig.5 Fig. 3 2. SVENSKA DANSK 3.
Installation instructions Fig. 6 –10 ° ° +30 Fig. 6a 90° 1 2 1 Fig. 7 –10 ° ° +30 O.K. 2 –10° 90° Fig.
Installation instructions C-1 7 10 6 3 2 7 8 5 6 1 3 4 2 C-3 8 11 A 13 16 19 9 12 5 1 9 C-2 4 2 D 10 1 15 18 14 17 20 3 5 7 4 6 8 1 3 5 7 2 4 6 8 C 1 2 3 4 5 6 7 8 B A Gala/Tacho Tel.-Mute (active low) RFLS Permanent +12V Aut.
Installation instructions Control cable (Power Antenna +) The control cable is the connected positive output for auxiliary components e.g.: power antennas, (maximum load < 150 mA). Important! Do not connect the control cable to terminal 15 (Plus connected) or terminal 30 (continuous plus).
