Owners Manual

ManualsBrandsBlaze Grills ManualsShop All Blaze GrillsBlaze Grills 35000 BTU Single Side Burner for Built-In Grills

Page |

POWER BURNER

MODEL # BLZ-PB-LP/NG & BLZ-PROPB-LP/NG

INSTALLATION AND OPERATING

INSTRUCTIONS

INSTALLER: Leave these instructions with consumer.

CONSUMER: READ & retain for future reference.

Important: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION

SAFETY WARNINGS & CODES

DANGER

IF YOU SMELL GAS:

1. Shut off the gas to the appliance.

2. Extinguish any open flame.

3. Remove lid to vent.

4. If odor continues, keep away from the

appliance, and immediately call your

gas supplier or fire department.

WARNING

1. Do not store or use gasoline or other

flammable vapors and liquids in the

vicinity of this or any other appliance.

2. A propane cylinder not connected for use

shall not be stored in the vicinity of this

or any other appliance with flame.

CODE AND SUPPLY REQUIREMENTS: This power

burner must be installed in accordance with local codes

and ordinances, or, in the absence of local codes, with

either the latest National Fuel Gas Code (ANSI Z223.1/

NFPA 54), and Natural Gas and Propane Storage and

Handling Installation Code (CSA-B149.1).

This appliance and its individual shutoff valves must

be disconnected from the gas supply piping system

when testing the system at pressures in excess of

½ psi (3.5 kPa).

This appliance must be isolated from the gas supply

piping system by closing its individual manual

shut-off valves during any pressure testing of the

gas supply system at pressures up to and including

½ psi (3.5 kPa).

WARNING

Improper installation, adjustment, alteration,

service, or maintenance can cause injury or

property damage. Refer to this manual. For

assistance or additional information consult

a qualified professional installer, service

agency, or the gas supplier.

All electrical outlets in the vicinity of the power

burner must be properly grounded in

Accordance with local codes or, in the

absence of local codes, with the National

Electrical Code, ANSI/NFPA 70, or the

Canadian Electrical Code, CSA C22.1,

whichever is applicable.

Keep all electrical supply

cords and fuel supply

hoses away from any heated surface at all

times including any sharp object.

Summary of content (17 pages)

PAGE 1
Page |1 POWER BURNER MODEL # BLZ-PB-LP/NG & BLZ-PROPB-LP/NG INSTALLATION AND OPERATING INSTRUCTIONS INSTALLER: Leave these instructions with consumer. CONSUMER: READ & retain for future reference. Important: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION SAFETY WARNINGS & CODES DANGER IF YOU SMELL GAS: 1. Shut off the gas to the appliance. 2. Extinguish any open flame. 3. Remove lid to vent. 4.
PAGE 2
Page |2 Safety and Installation Instructions When using your Power Burner, please read and follow these basic precautions: POWER BURNER INSTALLATION This Outdoor-cooking appliance (Power Burner) must be installed in accordance with all local and state codes INSPECTED by your local CITY & Fire department. If installation is planned in an area with no local codes, the gas Appliance must be installed in accord with the National Fuel Gas Code ANSI Z223.
PAGE 3
Page |3 GENERAL SAFETY REQUIREMENTS: 1. The installation of this appliance must conform with local codes or, in the absence of local codes, Either the National Fuel Gas Code, ANZI Z223.1/NFPA 54, or CAN/CGAB149.1, Natural Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code. 2. This outdoor cooking gas appliance is not intended to be installed in or on recreational vehicles and /or boats. 3.
PAGE 4
Page |4 WHERE TO INSTALL THE POWER BURNER IMPORTANT: THIS POWER BURNER IS FOR OUTDOORS USE ONLY. WARNING The power burner must be installed in masonry or other type of noncombustible surround. The unit is not insulated and therefore must be installed or placed with 16" of side and back clearance from combustible materials such as wood, plastic, or stucco with wood framing.
PAGE 5
GAS SAFETY REQUIREMENTS Page |5 Each appliance is set and tested at the factory for the type of gas supply to be used. Identify the Type of gas, either natural gas or LP (Liquid Propane) gas and make sure that the marking on the rating plate located on the side of the unit matches the gas being supplied to the Power Burner. The rating plate is located on the outside front left of the Power Burner.
PAGE 6
LP GAS HOOK-UP Page |6 Although the standard 20lb 5 gallon LP gas cylinder may be used, this size of a tank is more Susceptible to freezing up and potentially causing a safety risk. This freezing of the tank is caused due to the large gas consumption of this power burner and can be minimized by hooking into a larger L.P gas tank located away from the unit. Please make sure that you have met the entire city and State requirements as well as the fire department requirements.
PAGE 7
NATURAL GAS INSTALLATION – Page |7 The installation must conform with local codes or, in the absence of local codes, with either the national Fuel Gas Code, ANSI Z223.1/NFPA 54, or CAN/CGA-B149.1, Natural Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code. 1. This gas appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at the test pressures in excess of 1/2 psi (3.5 kPa). 2.
PAGE 8
Page |8 LEAK TEST CAUTION BEFORE TESTING Finding and/or fixing a gas leak is NOT a “DO-IT-YOURSELF” procedure. NEVER USE THE POWER BURNER WITHOUT FIRST LEAK TESTING THE GAS CONNECTIONS. WARNING: DO NOT USE OPEN FLAME TO CHECK FOR LEAKS. USE OF AN OPEN FLAME COULD RESULT IN A FIRE, EXPLOSION AND BODILY HARM. DO NOT SMOKE WHILE PERFORMING THE LEAK TEST! IF AT ANYTIME YOU SMELL GAS – SWITCH OFF ALL OF YOUR EQUIPMENT AND CALL A PROFESSIONAL TO DETECT THE GAS LEAK.
PAGE 9
Page |9 TYPICAL BUILDING DIMENSIONS Version 1.
PAGE 10
P a g e | 10 NOTE: Its is recommended to Build the Power Burner at least 6”-12” lower than the countertop CLEARANCE TO COMBUSTIBLE CONSTRUCTION. NOTE: The island construction cannot be made from combustible construction. A minimum clearance of 16” from the sides and back of the Power Burner to adjacent vertical combustible construction must be maintained.
PAGE 11
P a g e | 11 CLEANING & MAINTENANCE SPIDER AND INSECT WARNING Spiders and other insects can nest in the burner of this and any other Power Burner, which causes the gas to flow from the front of the burner. This dangerous “condition” can cause a fire behind the valve panel, damaging the Power Burner and making the Power Burner unsafe to operate.
PAGE 12
P a g e | 12 BURNERS CLEANING & MAINTANANCE Burners are made of heavy gauge stainless and can be cleaned using a bristle brush, warm water and soap. Check every port hole for clogs. Use a wire pin to clean out clogged ports. Make sure the burner is dry before installing it back to the Power Burner. WARNING! IT IS CRITICAL THAT THE GAS BURNERS ARE PROPERLY INSTALLED WITH THEIR ORIFICES INSIDE THE BURNERS AIR SHUTTERS.
PAGE 13
P a g e | 13 TO LIGHT THE POWER BURNER’S BURNER Lighting the Power Burner 1. Open the gas supply shut-off valve. 2. Push in the knob and turn to the left until you hear gas escaping. Wait a few seconds and then complete the turn where you will hear the click of the flame thrower ignition system to ignite the burner. If the igniter does not light turn to the right and OFF position, verify that the gas is on and then try again. 3. Once you see or hear a flame you can adjust the burner to the desired position.
PAGE 14
P a g e | 14 POWER BURNER PARTS LIST 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Flame Ring Burner Valve Control Knob Bezel Control Panel Manifold Drip tray Firebox Lid Lid handle Grate-Outer Grate-Inner Round NG Orifice-Inner Burner NG Orifice-Outer Burner LP Orifice-Inner Burner LP Orifice-Outer Burner Led Light Switch LED Light - RED Transformer PRO-SERIES BLZ-PB-001 BLZ-PB-002 BLZ-PB-003 BLZ-PROPB-004 BLZ-PROPB-005 BLZ-PROPB-006 BLZ-PB-007 BLZ-PROPB-008 BLZ-PROPB-009 BLZ-PB-0010 BLZ-PB-0011 BL
PAGE 15
Warranty Registration P a g e | 15 If you have purchased a Blaze Series Power Burner you must register your product within 30 days of purchase to validate the warranty and maintain your original receipt to get parts for the appliance. You may register your appliance at blazegrills.com by selecting Support, and then selecting Register your Product. You may also fill out page 1 6 - 1 7 and mail to the address located at the bottom of the form.
PAGE 16
P a g e | 16 The serial number for your BLAZE appliance is located on the left hand outs ide of the Firebox (see picture on page 11.) You will need this number to properly register your appliance and activate coverage. Write this information in the space provided below for your records Appliance model: Appliance serial number: Type of fuel being used: □ Propane □ Natural Gas Date purchased: Date installed: Blaze dealer ’s name & address: Blaze dealer ’s phone number: Version 1.
PAGE 17
P a g e | 17 Blaze Product Registration Please take a minute to let us know what you bought. This makes sure we keep you up to date and have your info ready if you ever need warranty help! You may register your product electronically on the blaze website vs mailing in the below paperwork, blazegrills.com.