USE & CARE GUIDE PORTABLE GAS GRILLS BLZ-1PRO-PRT(LP), BLZ-1PRO-PRTMG(LP) DANGER - IF YOU SMELL GAS: WARNING I) Shut off the gas supply to the appliance at its source. I) Do not store or use gasoline or other flammable 2) Extinguish any open flames. liquids or vapor in the vicinity of this or any other 3) Open grill hood to release any accumulation of appliance gas vapor.
Table of Contents I. BBQ Specifications 3-4 II. General Safety and Installation Warnings 5-9 i. Location of Appliance 9-12 III. Electrical Safety and Installation Warnings 13-14 IV. Gas Safety and Installation Warnings 14-15 V. i. Checking for Gas Leaks 16-18 ii. Unpacking Unit 18 Gas Connections 19 i. Liquid Propane Gas and Tank Requirements 19 ii. Transporting and Storing LP Gas 20-21 VI. First Time Operation 22 i. Lighting the Appliance 22-23 ii.
THIS MANUAL APPLIES TO THE FOLLOWING BLAZE GRILLS Model: BLZ-1PRO-PRT Cutout Dimensions BTU Output Outer Material Total BTU Primary Ignition Secondary Ignition Cooking Grid Dimensions Total Cooking Area Flame Tamer Zone Cooking Rotisserie Kit (Motor & Forks) Burner Gas Type N/A 12,000 BTU Burner 304 Stainless Steel 12,000 Push N’ Turn Flame Thrower Match Light 19 5/8" X 10 1/4" 201sq.
BBQ SPECIFICATIONS NOTE: ALWAYS have equipment measured by Contractor before beginning any project.
IMPORTANT SAFETY INFORMATION Please read this manual carefully and before using your BLAZE GRILL to ensure proper operation, installation, servicing and to reduce the risk of fire, burn hazard and or other injury. This manual should be retained for your information NOTE: Improper installation and service or maintenance may cause property damage, injury or death. Do not operate this appliance without having read this manual.
When using your Blaze appliance, please read and follow these basic precautions: To reduce the risk of fire, electric shock, or injury, read and follow these basic precautions before installing/operating your appliance. APPLIANCE INSTALLATION This gas appliance must be installed in accordance with all local codes. If installation is planned in an area with no local codes, the gas appliance must be installed in accord with the National Fuel Gas Code ANSI Z223.
Have an ABC Fire Extinguisher accessible at all times. Never attempt to extinguish a grease fire with water or other liquids. IMPORTANT: Consult the AHJ (Authority Having Jurisdiction) or local contractor of any uncertainty. This unit is for outdoor use only! Do not operate in a building, garage or any other enclosed areas. This could result in carbon monoxide buildup which could result in injury or death.
FOR YOUR SAFETY NOTE: Check with City and Fire department for Local Building Codes. Do not attempt to heat unopened containers on the grill as pressure may build up and cause the container to explode. Never use charcoal or any other solid fuel in the grill. Never cook without the drip pan in place. Never operate this grill while under the influence of alcohol or drugs. Please read all instructions before installing or operating your gas appliance to prevent injury and appliance damage.
• Never lean over the cooking surface when lighting or operating the appliance. • Use cooking utensils with wood handles and insulated oven mitts when operating the appliance. • Do not store anything in the appliance. Make sure food is not forgotten in the appliance; forgotten items could melt or catch fire when the appliance is turned on. • To prevent injuries, do not use accessories that are not recommended by the manufacturer. • Never use the appliance in windy conditions.
• Do not store combustible materials, gasoline or flammable liquids or vapors around the appliance. • This BLAZE GRILL must be located outdoors only. As with any gas appliance, harmful carbon monoxide is produced during the combustion process that should not be allowed to accumulate in a confined space. Please note since hot air rises above the BLAZE GRILL while in operation, covered locations should be avoided. Do not locate the BLAZE GRILL where an overhang or awning may cover it.
with a vent hood. The vent hood must provide protection for the combustible overhead construction. o It is imperative a Blaze grill is not installed under unprotected combustible overhead construction. o When installing under non-combustible construction, a vent hood is still recommended. Gas appliances produce a large amount of smoke. The covered area should be properly vented.
• Children should not be left alone or unattended in an area where any appliance is in use. They should never be allowed to touch, sit or stand on any part of the appliance. • Do not store items of interest to children in cabinets above the appliance or in the appliance. Children climbing on the appliance to reach these items could be seriously injured. • Wear proper clothing when operating this appliance. Loose-fitting or hanging garments should never be worn while using the appliance.
Electrical Safety and Installation Warnings Although your Blaze Portable Grill doesn’t use electricity, the following safety instructions and warnings should be followed around the grill and cooking area. Extension cords may be used if care is exercised in their use.
Be certain your appliance is properly installed and grounded by a qualified technician in accordance with applicable codes. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. The manufacturer cannot be held responsible for damages caused by the lack or inadequacy of an effective grounding system.
This Lp appliance may be used with either a standard 20LB., 12 ¼” diameter: 18” high cylinder with right handed connection threads and this is the maximum size lp tank allowed. By way of the included transition fitting, a smaller disposable lp tank is permitted. Use only those with a CGA#600 connection and a capacity of either 14.1 oz or 16.4 oz . The cylinder must be marked in accordance with the latest U.S. Department of Transportation specifications for LP gas cylinders or small tank. (DOT.
GAS LEAK WARNINGS Finding and/or fixing a gas leak is NOT a “DO-IT-YOURSELF” procedure – ONLY USE A PROFESSIONAL. NEVER USE THE GRILL WITHOUT FIRST LEAK TESTING THE GAS CONNECTIONS INCLUDING ALL OF THE VALVES, FITTINGS, LINES ETC. (ANY GAS CONNECTION SHOULD BE CHECKED) WARNING: DO NOT USE OPEN FLAME TO CHECK FOR LEAKS. USE OF AN OPEN FLAME COULD RESULT IN A FIRE, EXPLOSION AND BODILY HARM. DO NOT SMOKE WHILE PERFORMING THE LEAK TEST. Any Open Flame will ignite the gas.
sealant or tape in the event of a flared connection or by replacing the faulty part with a replacement part recommended by the manufacturer. Do not attempt to repair the Lp tank valve if it is damaged. The cylinder must be turned over to a proper LP tank servicer and then replaced. • If you are unable to stop a leak turn all control knobs back to the full OFF position, and shut off the gas supply to the appliance. • On LP systems, remove the cylinder from the appliance.
Open the valve (shut-off or ‘ON’ LP tank). Test for leaks by applying liquid soap solution to all joints. Bubbles forming indicate gas leak. • The following diagram is for informational purposes only. These locations are not the only points to check nor the only potential areas for a gas leak to be present. Ensure the leak test includes all valves, pipe connections, joints, lines and every point from the gas source to the burners. NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
Gas Connections Liquid Propane (LP) Gas and Tank Requirement • If your BLAZE Grill is for a Liquid Propane application, a L.P regulator set for 11” WC must be used and is for use with LP gas only. • The regulator and hose supplied must be used with a 20 lb. LP cylinder, or 1lbs small tanks by way of supplied fitting. • A collar to protect the cylinder threads on the customer supplied tank. • An arrangement for gas vapor withdrawal.
Filling and Refilling LP Gas Cylinders: • Turn control knobs and cylinder valve to the OFF position. Unscrew valve. • Remove cylinder and have it filled at your local qualified propane dealer. • Once filled, carefully connect the valve and make sure it is secure and not leaking. • With the control knobs in the OFF position, turn on the cylinder valve. If you smell gas or hear a hiss of gas escaping from the tank, get away from the tank and do not attempt to correct the problem yourself.
building materials that could cut, melt, or damage the line. A separate approved gas line might be needed to go between the hose and regulator and the grill to position the rubber line in a safe location. 4A (20 LB cylinder): Connect the regulator to the LP cylinder. Only hand-tighten the regulator. 4B. (disposable tank) Ensure the included fitting is secured tightly to the included Lp regulator. Insert the cylinder connection into the fitting and turn clockwise until tight.
FIRST-TIME OPERATION - Caution: Never operate the appliance unattended. The surface is extremely hot and someone can touch the hot surface and get seriously burned. All gas appliances should be attended at all times. Prior to using your appliance, verify that all of the following is correct: The burner tube is free of any debris or obstruction. Installation of the proper gas type and regulator settings. The proper gas connection is complete. Check for gas leaks.
Immediately. 5. If the burner does not light in 5 seconds, turn the burner off and wait five minutes with the lid open until the gas clears before attempting to light it again. Repeat the procedure or try the manual lighting procedure below. 6. If the burner does not light after several attempts, immediately close all gas valves and consult an authorized service technician. 7. Upon successful lighting, repeat the process on the other burners you wish to light. 8.
“FLASHBACK” may occur in or around the burner tubes. Flashback exhibits a characteristic “whooshing/jet like” sound. If this should occur, immediately turn off your burners, then remove and clean them with soap, water and a brush until all foreign objects are removed. Before cooking with your appliance for the first time, burn off any foreign matter and rid the unit of any odors by burning the main burners only on HIGH with the lid down for about 10 minutes.
Cleaning Your Appliance WARNING: Always be sure the grill control is turned off and the grill is cool before using any type of aerosol cleaner on or around the grill. The chemical that produces the spraying action could, in the presence of heat, ignite or cause metal parts to corrode. NOTE: You should clean your appliance after each use to maintain the overall appearance over the life of your appliance.
Clean the drip tray after each use. Failure to do so could result in a fire. The tray is located underneath the grill body and can be removed from the left hand side of the unit. Once the appliance has cooled completely, remove the tray by pulling it all the way out until it comes free. Clean the tray with hot soapy water and re-install. If using an oven cleaning agent, be sure to carefully follow the manufacturer’s instructions to avoid damage to the stainless steel.
Warranty Registration If you have purchased a Blaze Series Grill you must register your product within 30 days of purchase to validate the warranty and maintain your original receipt to get parts for the appliance. You may register your appliance at blazegrills.com by selecting Support, and then selecting Register your Product. You may also fill out page 28 - 29 and mail to the address located at the bottom of the form.
BLZ-1PRO-PRT / BLZ-1PRO-PRTMG Blaze Outdoor Products Instructional Book Page | 28
For Your Records: Fill out the form below. This information will be required in the event of a warranty claim.
Blaze Product Registration Please take a minute to let us know what you bought. This makes sure we keep you up to date and have your info ready if you ever need warranty help! You may register your product electronically on the blaze website vs mailing in the below paperwork, blazegrills.com.
