Blaze Portable Manual
Table Of Contents
- USE & CARE GUIDE
- ATTENTION:
- - CONTACT INFORMATION –
- NOTE:
- FOR YOUR SAFETY
- If you smell gas:
- When using your Blaze appliance, please read and follow these basic precautions:
- Have an ABC Fire Extinguisher accessible at all times. Never attempt to extinguish a grease fire with water or other liquids.
- This unit is for outdoor use only!
- Please read all instructions before installing or operating your gas appliance to prevent injury and appliance damage.
- Location of Appliance
- - CONTACT INFORMATION –
- Electrical Safety and Installation Warnings
- Although your Blaze Portable Grill doesn’t use electricity, the following safety instructions and warnings should be followed around the grill and cooking area.
- ATTENTION:
- Gas Safety and Installation Warnings
- Gas Connections
- Cleaning Your Appliance
- Exterior Cleaning
- Flame Tamers, Cooking Grids and Warming Racks
- Cast Stainless Steel Burner
- Drip Tray & Internal Cleaning
- Warning: Due to the compact design of a portable grill, the drippings from cooking accumulate at a faster rate than a full sized grill. The inner body of the grill should be cleaned before each use to eliminate the buildup of grease and potential f...
- BLZ-1PRO-PRT / BLZ-1PRO-PRTMG
- For Your Records:
Blaze Outdoor Products Instructional Book
Page | 14
Be certain your appliance is properly installed and grounded by a qualified technician in accordance with
applicable codes. To guarantee the electrical safety of this appliance, continuity must exist between the
appliance and an effective grounding system. It is imperative that this basic safety requirement be met. The
manufacturer cannot be held responsible for damages caused by the lack or inadequacy of an effective
grounding system.
This appliance conforms to all uniform electrical safety codes and electrical grounding regulations. Install unit
according to I.A.W. local codes or with National Electrical Code ANSI/NFPA 70 or CSA C22.1 in their absence.
Gas Safety and Installation Warnings
•
All gas connections should be made by a Professional qualified technician and in accordance with local
codes and ordinances. The installation must conform with local codes or, in the absence of
local codes, with either the national Fuel Gas Code, ANSI Z223.1/NFPA 54, or CAN/CGA-B149.1,
Natural Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code.
•
Always check the Rating Plate to make sure the gas supply you are hooking up to is the gas type
the appliance is manufactured for.
•
Do not twist the gas supply hose.
•
Before each use, visually inspect the gas supply hose for cracks, cuts or excessive wear. Replace
the hose if necessary. Check for gas leaks before each use.
•
Never connect the appliance to an unregulated gas supply line. Appliances operated without a regulator
are unsafe and will not be serviced until installed properly and safely. Unsafe operation without a gas
regulator will void the warranty of the appliance.
•
When using the grill as a Portable or Table model, place the LP gas tank as far away from the grill as
possible in a safe and upright position maintaining 12 inches of clearance on all sides and locating tank
and hose in a position to prevent tipping.
•
This appliance operates with with LP (liquid propane) gas and must be installed with an LP regulator
set to 11"water column pressure.
•
Please contact your dealer and use a licensed contractor or installer to convert your appliance to the
different gas type.
•
CHECK TO ENSURE THAT THE GAS SUPPLY HOSE DOES NOT COME IN CONTACT WITH ANY
HOT SURFACE, SHARP OR ROUGH EDGES OF THE GRILL OR OUTDOOR KITCHEN
CONSTRUCTION. DO NOT KINK THE GAS LINE WHEN INSTALLING.
•
Do not store a spare gas tank under or within 25 feet of this grill or any other open flame, heat
producing appliance or heat source.
•
When your grill is stored indoors, remove and store the LP gas tank outdoors in a protected, cool,
ventilated, and dry location.