Blaze Portable Manual
Table Of Contents
- USE & CARE GUIDE
- ATTENTION:
- - CONTACT INFORMATION –
- NOTE:
- FOR YOUR SAFETY
- If you smell gas:
- When using your Blaze appliance, please read and follow these basic precautions:
- Have an ABC Fire Extinguisher accessible at all times. Never attempt to extinguish a grease fire with water or other liquids.
- This unit is for outdoor use only!
- Please read all instructions before installing or operating your gas appliance to prevent injury and appliance damage.
- Location of Appliance
- - CONTACT INFORMATION –
- Electrical Safety and Installation Warnings
- Although your Blaze Portable Grill doesn’t use electricity, the following safety instructions and warnings should be followed around the grill and cooking area.
- ATTENTION:
- Gas Safety and Installation Warnings
- Gas Connections
- Cleaning Your Appliance
- Exterior Cleaning
- Flame Tamers, Cooking Grids and Warming Racks
- Cast Stainless Steel Burner
- Drip Tray & Internal Cleaning
- Warning: Due to the compact design of a portable grill, the drippings from cooking accumulate at a faster rate than a full sized grill. The inner body of the grill should be cleaned before each use to eliminate the buildup of grease and potential f...
- BLZ-1PRO-PRT / BLZ-1PRO-PRTMG
- For Your Records:
Blaze Outdoor Products Instructional Book
Page | 17
sealant or tape in the event of a flared connection or by replacing the faulty part with a replacement part
recommended by the manufacturer. Do not attempt to repair the Lp tank valve if it is damaged. The
cylinder must be turned over to a proper LP tank servicer and then replaced.
•
If you are unable to stop a leak turn all control knobs back to the full OFF position, and shut off the
gas supply to the appliance.
•
On LP systems, remove the cylinder from the appliance.
•
Call an authorized gas appliance service technician or an LP gas dealer.
•
Do not use the appliance until the leak is corrected.
•
The below diagram is intended to show what a leaking connection would look like. These two locations
are not the only points to check nor the only potential areas for a gas leak to be present.
•
All gas piping and connections must be tested for leaks after installation or service along with before each
use.
This includes all valves, pipe connections, joints, lines and every point from the gas
source to the burners.
•
All leaks must be corrected immediately.
•
Remember-before exchanging an empty bottle for a new one; make sure all control valves
are in the “off” position. This can create a low flow of gas through the grill. This would require
the tank to be disconnected from the regulator, and then reconnected to reset the regulator.