Owners Manual

• Check to be sure you have all of the following parts:
• 3
Shelves
• 1 Glass Lid
• 1 Crisper
• 1 Instruction Manual.
• Clean the interior surface with lukewarm water using a soft cloth.
• Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a lukewarm wet cloth.
• Place the appliance on a floor that is strong enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or near sources of heat, such as a stove or
heater, as this can increase electrical consumption. Extreme cold ambient temperatures may
also cause the appliance to perform improperly.
• Do not use the appliance near water, for example in a wet basement or near a sink.
• Before connecting the appliance to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
The appliance should be installed in accordance with local electrical code requirements. It should also
be placed in a location that is strong enough to support its total weight, keeping in mind that it will
weigh substantially more when fully loaded than when empty.
Before you plug the appliance into a power supply, be sure to let it stand upright for at least 24 hours
to allow the compressor’s oils to settle.
WARNING: Use two or more people to move and install the appliance. Failure to do so can result in
back or other injury. Carefully remove the packaging materials. Remove any shipping tape and glue
from your appliance before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can damage the surface of your appliance.
IMPORTANT SAFETY GUIDELINES CONT'
Location and Installing Your appliance
(A) Before Using Your Unit
(B) Installing Your Unit
• This appliance is designed to be free standing only, and should not be recessed or
built-in. Allow 5 inches of space between the back and sides of the unit, which allow proper
air circulation to cool compressor and condenser.
• Place your unit on a floor that is strong enough to support the unit when it is fully
loaded. To level your unit, adjust the two leveling legs at the bottom of the unit.
• Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized Products service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours
before placing content in the refrigerator compartment.
6
www.blazegrills.com