Specifications
OM-CK20 E V1.13 October 18, 2013
Page 16
CHINOOK 20
INSTALLATION INSTRUCTIONS cont.
OPTIONAL ACCESSORIES
Outside air kit, Rear Shield or Fan Kit are optional accessories, but are required for the following
installations:
MOBILE HOME INSTALLATION — Requires Outside Air Kit and Fan Kit or Rear Shield
RESIDENTIAL ALCOVE — Requires Fan Kit or Rear Shield
REAR SHIELD KIT (R/SP1006)
EITHER this Rear Shield OR the Fan Kit (P/N Z2514) is REQUIRED FOR:
MOBILE HOME, any installation
RESIDENTIAL ALCOVE
TOOLS NEEDED FOR INSTALLATION: Phillips or square drive screwdriver.
INSTALLATION : e rear shield goes across the back of the stove, just below the thermostat
knob. Place shield into position, insert and tighten the two #10 X 1 1/4" screws provided.
FAN KIT (P/N Z2514)
EITHER this Fan Kit or the Rear Shield (R/SP1006) is REQUIRED FOR:
MOBILE HOME, any installation
RESIDENTIAL ALCOVE
NOTE: Fan Kit should be installed before the stove is placed into position
INSTALLATION: See instructions included with Fan Kit. Tools needed: Square (Robertson no.
2) screw driver and a 5/32” Allen wrench.
ELECTRICAL CONNECTION
Your Blaze King fan kit is equipped with a three-prong (grounded) plug to decrease shock hazard.
THIS PLUG SHOULD BE INSERTED DIRECTLY INTO A PROPERLY-GROUNDED, THREE-
HOLE RECEPTACLE. DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM THIS
PLUG. Do not route the power cord in front or under the stove.
OUTSIDE AIR KIT (P/N 1726B)
REQUIRED FOR: MOBILE HOME (any installation)
e outside air inlet hose is a exible tube to bring outside air for combustion into the stove from
outside the residence, through the wall or up through the oor. e exible tube will allow some
adjustment over or around oor joists or plumbing. DO NOT CHANGE THE STRUCTURAL
INTEGRITY OF THE FLOOR. is air hose must be kept open at all times to provide outside air
for combustion.
INSTALLATION
See instructions included with the Outside Air Kit. Tools needed: 1/4" or 3/8" drill motor, Saber
saw, Saber saw wood & metal blades, 5/16" nut driver or wrench, 7/16" wrench, Small tube of
hi-heat silicone.