Specifications

Date Printed: February 15, 2008 16 Version 1.02
ADJUSTING THE DOOR CATCH TENSION
The door catch on the front of the stove is adjustable. If you need to adjust the door to ensure a
gasket air seal around the door, loosen the lock nut. Rotate the catch clockwise to tighten the gasket.
Make this adjustment one turn at a time and be careful not to over tighten, that could place excess
strain on the door and glass.
REPLACING THE DOOR GASKET
1) If the door gasket is to be replaced, be sure you have a replacement part ready to re-install. See
your Blaze King dealer.
2) Be sure the fire is out and the stove has cooled down. The door does not have to be removed
from the stove. With a pair of pliers, pull the old door gasket out of the channel and dispose of it.
3) Clean out the channel so the new gasket can fit smoothly.
4) Run a small bead of a door gasket adhesive (see your Blaze King dealer) or high temperature
silicone adhesive along the center of the channel. Start the new gasket in the lower right corner. Do
not stretch or cut the gasket. Distribute the gasket evenly around the frame.
5) Adjust the door catch on the stove front to ensure a proper seal, do not over tighten the door catch
as it could place too much pressure on the door frame and glass. See "Adjusting the door catch
tension" above.
6) Close the Loading Door and allow the adhesive to dry.
7) Check the fit of the door gasket. Insert a piece of paper into the door opening and close and latch
the door. Obvious resistance should be felt when pulling the paper out. Repeat this check several
times around the perimeter of the door. See "Adjusting the door catch tension" above.
GOLD DOOR MAINTENANCE
The gold plating on the door is 24k gold and hence very soft. Do not use any abrasive cleaners on
the gold, just a damp cloth. Use of abrasive cleaners will void the warranty.
CLEANING THE GLASS
While the glass may coat during a low (overnight) burn, adjusting the thermostat to the warmest
setting after reloading each morning will usually allow the glass to clean. Heavier deposits may
require hand cleaning. Manual glass cleaning should be done when the stove and glass are cold.
DO NOT CLEAN THE GLASS WHILE IT IS HOT. Use a soft cloth and wood stove glass cleaner,
available from most Blaze King dealers. Other NONABRASIVE household cleaners may also work.
After using any cleaner, thoroughly rinse the glass with water to remove any deposits left by the
cleaner. Failure to remove all traces of glass cleaner will result in the glass cleaner residue baking
on. This residue will be very difficult to remove.
LOADING DOOR GLASS REPLACEMENT
Your BLAZE KING is equipped with a door which uses a strong, heat resistant ceramic glass
intended to withstand extremely high temperatures and tested for continuous use above 1200
degrees Fahrenheit. However, this glass can be broken through improper use. If glass replacement
becomes necessary, use only BLAZE KING replacements. DO NOT SUBSTITUTE ANY OTHER
MATERIAL FOR THIS PURPOSE.