Outdoor Refrigerator User Manual Model: BLZ-SSRF-50DH Be sure unit is standing upright 24 hours prior to plug-in.
IMPORTANT SAFEGUARDS Read all instructions before using this appliance. Use this appliance only for its intended purpose as described in this instruction manual. Always exercise basic safety precautions, as described below. After reading the instruction manual, store it in an accessible place where the user(s) of this product can easily find it.
combustible gas is present near the appliance, turn off the source of the gas, then open the windows and doors to allow the gas to dissipate. To avoid an explosion, do not pull the plug or switch off the unit. 7. The electrical socket must have good grounding. The ground wire cannot be connected with a gas pipe, heating pipe, water pipe, telephone line or lightning rod. It cannot be replaced with the neutral wire of single-phase power.
7. Never pull out plug when hands are wet! 8. This unit is not intended for the storage of medicines or chemical reagents. 9. Keep packing materials away from children. 10. Condenser water from evaporator drains into a hole in the floor of the storage compartment and is channeled into a drain pan located at the back of the unit on the compressor. Heat transferred from the compressor evaporates any water that has collected in the pan. Be sure the drain hole in the floor of the unit is clear and unobstructed.
Table of Contents IMPORTANT SAFEGUARDS .............................................. 1 – 3 Location of Parts .........................................................................4 Technical Specifications ..............................................................5 Energy-Saving Tips .....................................................................5 Installation ............................................................................ 5 – 7 Operating Your Refrigerator ........................
Technical Specifications Model Number: BLZ-SSRF-50DH Description: Outdoor Refrigerator Electrical Input: 115VAC ~ 60Hz Current Rating: 1.8A Unit Dimensions: 23⅝”W x 23 1116 ”D x 33½”H Unit Weight: 93 lbs Ambient Temperature Range: 50ºF - 100ºF Compartment Temperature Range: 36ºF - 64ºF Control Panel F C F C Energy-Saving Tips • Do not place the unit next to a heating vent, a range or in direct sunlight. • Keep the door closed as much as possible, especially in hot, humid weather.
The Refrigerator is designed to be either free-standing or built-in. It has motorized fans at the back of the unit that direct compressor-generated heat away from the compressor and through the front of the unit. Keep the front vents unobstructed. If the unit is built-in, allow minimum clearances of 1/4” at the sides, 1/2” at the back and 1” at the top. Once the Refrigerator is positioned, the adjustable legs should be turned to level the appliance. This will reduce vibrations.
To replace door on hinges: 3. Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the door hinges, top and bottom. Set aside. 4. Replace the axis on the Hinge 1 and tighten it firmly. Remove Hinge 1 and place it on the opposite bottom side. 5. Remove Hinge 2 and place it on the opposite top side. Separate the axis from Hinge 2 and set it aside. 6. Align the door on Bottom Hinge 1 and replace axis on Hinge 2. Tighten it firmly.
equipped with a cord having a grounding wire with a grounding plug. The plug must be inserted into an outlet that is properly grounded and installed. The ground wire cannot be connected to a gas pipe, heating pipe, water pipe, telephone line or lightning rod. It cannot be replaced with the neutral wire of single-phase power. In addition to the ground wire, an electrical leakage circuit breaker is also required. Consult a qualified electrician if you do not completely understand these grounding instructions.
If you want to use the Automatic Temperature (default) setting, do nothing further. The unit will automatically set the temperature in the compartment at 40 ºF (4ºC). If you want to set other temperatures, see below. Temperature Setting Wine Storage Temperatures: While wines store best at temperatures around 5658ºF, your unit also allows you to store wine at drinking temperatures. Generally, RED WINE should be kept at 60-61ºF and WHITE WINE, which is usually served chilled, is best kept at 54-55ºF.
NOTE: If you unplug the Refrigerator, allow 3 minutes before plugging it back in. The unit will not restart in less than 3 minutes. Memorized Temperature Settings Your unit has been designed to “remember” the last run mode to which it was set. If there is a power outage or any other power cutoff, the unit will automatically return to the previous temperature setting after the power has returned.
Cleaning and Maintenance Cleaning the Outside Unplug your Refrigerator. Clean the outside with a cloth dampened in mild soapy water. Dry thoroughly with a soft cloth. Polish with a stainless steel cleaner. To clean the door gasket, use only mild soapy water. Never use harsh cleansers or scouring pads to clean any part of your unit. Cleaning the Inside Unplug your Refrigerator and remove its contents. Rinse the inside surfaces with plain water and dry the chrome racks, basket and shelving.
Troubleshooting Unit does not turn on Not plugged in. Fuse blown or circuit breaker tripped. Press Power Button on control panel Noise or vibration Check that unit is level. If not, adjust leveling legs. Unit is too warm Check that door is properly closed and sealed. Check temperature setting. (To change the temperature setting, follow the steps in the Operating Your Refrigerator section of this manual.) Check if door has been opened frequently or recently filled with product.
Limited Warranty Manufacturer warrants to the original purchaser at the original site of delivery with proof of purchase of each Refrigerator that when subject to normal residential use, it is free from defects in workmanship and material for the periods specified below. This warranty excludes refrigerators used in rental or commercial applications. It does not cover labor or labor related charges. There will be shipping and handling charge for the delivery of the warranty part(s).