Owner's Manual
PART# BBE-2027
Bien
ESCORT
JR
NI
Innovative
Mounting
Solut
i
ons
CLAMP
SCREW
CLAMP
SCREW MUST
BE SLIGHTLY LOOSENED
BEFORE MAKING
ROTATING
ADJUSTMENT
BE
SURE
TO
RETIGHTEN
AFTER
ADJUSTMENT
IS
MADE
ROTATING
ADJUSTMENT
DRIVER'S PERSPECTIVE
WITH NO ROTATING
ADJUSTMENT USED
DRIVER'S PERSPECTIVE
WITH RADAR ROTATED
TOWARDS DRIVER
STEP 3 • Install your radar detector onto the mount. Use the adjustments shown above to adjust the RD
to
your desired position. We recom-
mend adjusting the RD as close to the bottom
of
your mirror as you can. NOTE When the rotating adjustment is used to rotate the RD towards
the driver, the footprint
of
the RD is reduced as shown above. Be sure to tighten all
of
the adjustment screws after the adjustments are made.
STEP 4 • With the RD adjusted right below the mirror as recommended, you will probably not be able to
get
your fingers between the RD and mirror to
access the buttons. The spring clip allows you to push the front
of
the RD downward with one finger and press the buttons with another finger
as shown above.
NOTE : This mount can
get
extremely hot when sitting in direct sunlight.
If
you intend to remove your RD frequently, you
may
want
to install the two gray
'
TOUCH
STRIPS" included in the tool kit. Place them where your fingers make contact with the mount.
They
may
be trimmed with a blade
or
knife.
FOR MORE INFO VISIT www.blendmount.com/videos
CAUTION
DO NOT use this mount
if
it interferes with the adjustability
or
the operation
of
your rear view mirror in any
way
.
DO
NOT
use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO NOT ATTEMPT
TO
MODIFY THIS PRODUCT. Consult the manufacturer
for
assistance.
All BlendM01Jnt products are accompanied with detailed installation instructions and adjustment tips. You are encouraged to contact customerser rice@blend-
mount.com
or
call
J28
Design
at
1-888-497-8388 for further assistance.
Check the BlendMount Forum
for
installation tips and some vehicle specific installs.
www
.blendmount.com
Innovative
Design
And
Precision Manufacturing
PAGE 2 OF 2
Your feedback is very important to us. Please email
any
questions
or
comments you have to customerservice@blendmount.com
BlendMount - US
PATENT#
0625
,580 S,
0656
,
811
S,
0653
,980 S
0690
,245 S,
0690
,246 S,
0690
,247
Sand
other patents pending