Owner's Manual
PART# BBE-2130
Blend
fflount-
®
ESCORT
BEL
TRONICS .
Innovative
Mounting
Solutions
STEP 3 - While
sitti~
in
the passenger seat, place the mount over
tne
mi11t1r
stem. lighten the CLAMP SCREW until the mount starts
to
clamp onto the mirror stem. Position the mount as far
forward
as
it
will
go and paralell
to
the
bottom
of
the
mi11t1r
before fully tightening.
PIVOT
POINT
TOPANDMID
SECTIONS MUST
TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
STEP 4 - MAKE SURE
TllE
TOP AND
MID
SECllONS
ARE TOUCHING AT
TllE
PIVOT POINT.
If
you can not
get
them
to
touch at the pivot point, you
have
an lncompatlbla
mirror
type
for
this
mount.
PIVOT
ADJUSTMENT
STEP 5 - Reinstall the BODY
ASSEMBLY.
Be sure
to
Include the
lock washer with the top socket head screw and the lock and flat
washer
with
the bottom socket head screw
as
shown
above.
NOTE:
there are extra lock and flat washers Included
In
the tool kit
Just
In
case you happen
to
mlsplace one.
STEP
6 - Install your radar detector onto the mount.
U8e
the ad-
justments shown above
to
adjust the
RD
to your desired position.
We
recommend adjusting the
RD
as
cloae
to
the bottom
of
your
mirror
ea
you can. Be sure
to
tighten all adjustment screws after the
adjustments are made.
CAUTION
DO NOT use this mount If It Interferes with the adJustablllty or the operation
of
your rear view mirror
In
any
way.
DO
NOT
use this mount
If
the radar detector creates
an
unsafe viewing obstruction.
DO
NOT
ATTEMPT
TO
MODIFY THIS
PRODUCT.
Consult
the
manufacturer
for
assistance.
All BlendMount products are accompanied with detalled lnstallatlon Instructions and adjustment tips.
You
are encouraged to contact customerser flce@blend-
mount.com or call J28 Design at 1-888-497-«iBB for further aulstance.
Check the BlendMount
Forum
for Installation tips and aome vehicle spectnc Installs.
www.blendmount.com
Innovative
Design
And
P
recision
Manufactur
i
ng
PAGE20F2
Your feedback
Is
very Important
to
us. Please email any questions or
comments you have
to
cuatome1'98rvlce@blendmounlcom
Blend Mount-
US
PATENT# 0625,580 S,
DB56,811
S,
D653,980 S
0690,245 S, 0690,246
S,
D690,247 S and other patents pending