Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesUniversal-Fit Radar Detector Mount
12
PART# BCB-2000R
Blancl.
fflaun
1
111
1
111
m11111
111
11
~
.
Innovative
Mount
i
ng
Solut
i
ons
INSTALLATION INSTRUCTIONS FOR THE COBRA DSP•9200BT, SPX•7800BTn700, SPX-6700, AND iRAD 900 RADAR DETECTOR
3\4" INNER DIAMETER
7\8"
INNER DIAMETER
WITH BUSHINGS WITHOUT BUSHINGS
3 - This mount was designed
to
fit rear view
mirror stems that are 3/4" or 7/8"
in
diameter.
If the mount is too
big
to clamp onto your
mirror stem, use the two bushings.
1 - Install your radar detector (RD) onto
the mount before installing it
on
the rear
view mirror.
To
release tension
from
the
spring clip, simply squeeze the release tab
and
the back side of the mount together.
This will lower the bottom portion of
the
spring clip allowing
you
to slide
the
RD
on
and
off
the
mount.
BOTTOM OF SPRING CLIP
IS PARALLEL WITH RD
2 -
The
bottom of the spring clip must
be
parallel
with
the top of the
RD
to
slide
in
and out. Slide the
RD
onto the spring clip
as
far
as
it wlll
go
. Let go
of
the
release tab to secure the
RD
onto the mount. Before
installing the mount onto your rear view mirror, remove
and
install the
RO
a few times
so
you
can
observe how
the
pring
clip
functions.
Grab the mirror
and
move the stem
upward using the windshield pivot only
Mirror stem
can
pivot left/right to
point radar detector where desired
4 - Most compatible mirrors have a stem between the mirror and the windshield that has a pivot
on
both ends.
We
recommend that
you
try moving the mirror upward before Installing the
mount.
Grab the mirror and
move
the stem upward using the windshield pivot only. Adjust the mirror to
your normal viewing
pos
ition using the mirror pivot only. Notice the higher location of the mirror
as
shown above.
NOTE:
The mirror stem may move side to side a well. Make sure the
stem
po
ints straight ahead
so
the
RD
does too.
BLENDMOUNT CENTER LINK
5 - Install the mount while sitting
In
the passenger side of your
vehicle. Remove the right-top portion
of
the mount
and
position the
mount around the mirror stem
as
shown above. Reattach the right
side of the mount. Make sure the lock washer
is
still
on
the lower
clamp
screw.
Leave the top screw loose
so
the mount
can
slide
along the mirror stem and rotate to the desired location. There may
be
a plastic oval clip around a wire
and
the
stem
, the clip must
be
removed to install the mount. Lightly snug screws,
do
not fully
tighten until last step.
With
center
link installed
Without center
llnk Installed
6 - The center-link may
be
removed If
an
overall shorter mount length is
needed, depending
on
your rear view miror and desired position for the
RD
.
Innovative De ign And
Precision anufacturin
PAGE
1 OF 2
BlendMount -
US
PATENT# 0625,580 S,
D656
,811 S,
D653
,
980
S
D690,245 S,
D690
,246 S, D690,247
Sand
other patents
pend
i
ng

Summary of content (2 pages)