Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesUniversal-Fit Radar Detector Mount
12
PART# BMG-2001 R
1
IIII
~~
~
~IJIII!
l!IJIJIJ
ll
11
4
Blend
lllaunf-
®
Innovative
Mounting
Solutions
ESCORT
!,,cobra
'
INSTALLATION INSTRUCTIONS FOR ESCORT/COBRA/BELTRONICS EZ MAG MOUNT
RADAR
DETECTORS
1 - The magnet must be
removed from the suction
cup mount that the radar
detector came with.
2 - Unscrew and
remove bolt, only the
magnetic piece is used
with the blendmount.
3 - Install aluminum
threaded insert into
magnet, and attach
magnet onto blend-
mount with lip pointed
in
direction as shown.
314"
INNER DIAMETER
718"
INNER DIAMETER
WITH BUSHINGS WITHOUT BUSHINGS
Grab
the
mirror
and
move
the
stem
upward
using
the
windshield
pivot
only
Mirror
stem
can
pivot
left/right
to
point
radar
detector
where
desired
4 - This mount was designed to fit rear view
mirror stems that are 3/4"
or
7/8"
in
diameter.
If the mount is too big to clamp onto your
mirror stem, use the two bushings.
5 - Most compatible mirrors have a stem between the mirror and the windshield that has a pivot
on both ends. We recommend that you try moving the mirror upward before installing the mount.
Grab the mirror and move the stem upward using the windshield pivot only. Adjust the mirror to
your normal viewing position using the mirror pivot only. Notice the higher location
of
the mirror
as shown above.
NOTE
:
The
mirror
stem
may
move
side
to
side
as well.
Make
sure
the
stem
points
straight
ahead
so
the
RD
does
too
.
6 • Install
the
mount
while
sitting in
the
passenger
side
of
your
vehicle. Remove the right-top portion
of
the mount and position the
mount around the mirror stem as shown above. Reattach the right
side
of
the mount. Make sure the lock washer is still on the lower
clamp screw. Leave the top screw loose so the mount can
sl
ide
along the mirror stem and rotate to the desired location. There may
be a plastic oval clip around a wire and the stem, the clip must be
removed to install the mount.
Lightly
snug
screws
,
do
not
fully
tighten until
last
step.
Innovative Design
And
Precision Manufacturing
With
center
link
installed
BLENDMOUNT
CENTER
LINK
link
installed
7 - The center-link may be removed if an overall shorter mount length is needed,
depending on your rear view miror and desired position for the radar detector.
PAGE 1
OF
2
BlendMount- US PATENT#
0625
,580 S,
0656
,
811
S,
0653
,980 S
0690
,245 S,
0690
,246 S,
0690
,247
Sand
other patents pending

Summary of content (2 pages)