Owner's Manual

PART# BMG-2025
1 111111111~1 I 111
-, 2802"' 3656 3
Hlend mounf-®
Innovative Mount ing Solutions
ESCORT
LEFT HAND DRIVE VEHICLE
INSTALLATION INSTRUCTIONS FOR ESCORT IX, REDLINE EX, AND 360C RADAR DETECTORS
Your rear view mirror has minimal clearance between the back side of the mirror and the mirror stem. It is very important
that this mount is Installed correctly to ensure mirror adjustabillty is retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For Illustration purposes, th mount and rear view mirror shown In these Instructions may look slightly different than YOUR
mount and rear view mirror.
3 - Install aluminum threaded
insert into magnet, and attach
magnet onto blendmount with lip
pointed in direction as shown.
1 - The magnet must be removed from the suction
cup mount that the radar detector came with.
UNSCREW
HERE
2 • Unscrew and remove bolt, only the
magnetic piece is used with the blendmount.
CLEARANCE
FOR MIRROR
STEM
4 - The Body Assembly must be removed to gain access to the CLAMP SCREW.
Remove the two socket head screws as shown above. Be sure to remove the lock
washer with the top screw along with the lock washer and flat washer with the
bottom screw. Loosen the Clamp Screw so there is enough clearance between
the TOP and MID SECTIONS to slide over the mirror stem.
PAGE 1 OF2