Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesBlendMount BMX-2000R Universal-Fit Radar Detector Mount
12
PART# BMX-2000R
7
1111~~~~~UJIJIJIJII
18
3\4" INNER DIAMETER 7\8" INNER DIAMETER
WITH BUSHINGS WITHOUT BUSHINGS
3 - This mount was designed to fit rear view
mirror stems that are 3/4"
or
7/8" in diameter.
If
the mount is too big to clamp onto your
mirror stem, use the two b·ushings.
Blend
ffluunf-
®
ESCORT
PASSPORT
MAX
Innovative
Mounting
Solutions
INSTALLATION INSTRUCTIONS
FOR
ESCORT
MAX
SERIES
AND
BELTRONICS GT-7
RADAR
DETECTORS
1 - Install your radar detector {RD) onto
the mount before installing it on the rear
view mirror.
To
release tension from the
spring clip, simply squeeze the release tab
and the back side
of
the mount together.
This will lower the bottom portion
of
the
spring clip allowing you to slide the RD on
and off the mount.
BOTTOM OF SPRING CLIP
IS PARALLEL WITH
RD
2 - The bottom
of
the spring clip must be parallel with
the top
of
the RD to slide in and out. Slide the RD
onto the spring clip as
far
as it will
go
. Let go
of
the
release tab to secure the RD onto the mount. Before
installing the mount onto your rear view mirror, remove
and install the RD a few times so you can observe how
the spring clip functions.
Grab the mirror and
move
the
stem
upward using
the
windshield pivot only
Mirror stem can pivot left/right
to
point radar detector where desired
4 - Most compatible mirrors have a stem between the mirror and the windshield that has a pivot
on both ends. We recommend that you try moving the mirror upward before installing the mount.
Grab the mirror and move the stem upward using the windshield pivot only. Adjust the mirror to
your normal viewing position using the mirror pivot only. Notice the higher location
of
the mirror
as shown above.
NOTE
:
The
mirror stem
may
move side
to
side as well. Make sure the
stem points straight ahead so the RD does too.
BLENDMOUNT
CENTER
LINK
5 - Install the mount while sitting in the passenger side
of
your
vehicle. Remove the right-top portion
of
the mount and position the
mount around the mirror stem as shown above. Reattach the right
side
of
the mount. Make sure the lock washer is still on the lower
clamp screw. Leave the top screw loose so the mount can slide
along the mirror stem and rotate to the desired location. There may
be a plastic oval clip around a wire and the stem, the clip must be
removed to install the mount. Lightly snug screws,
do
not
fully
tighten until last step.
With center
link installed
Without center
link installed
6 - The center-link may be removed
if
an overall shorter mount length is
needed, depending on your rear view miror and desired position for the RD.
Innovative Design
And
Precision Manufacturing
PAGE 1
OF
2
BlendMount - US PATENT# D625,580 S, D656,
811
S, D653,980 S
D690,245 S, D690,246 S, D690,247
Sand
other patents pending

Summary of content (2 pages)