Owner's Manual

PART# BMX-2006
Blencl. ffloun
®
ESCORT PASSPORT MAX
11111111111, 111 1 11 1 I
Innovative Mount i ng So l ut ions
? 28028 3 717 6
INSTALLATION INSTRUCTIONS FOR THE ESCORT PASSPORT MAX RADAR DETECTOR
1 - The RELEASE Button on the radar detector (RD) is NOT used with this mount.
To release the tension of the spring clip, simply squeeze the TRIGGER and the back side
of the mount together. This will lower the bottom portion of the spring clip allowing you to
slide the RD on and off . When used properly, the spring clip avoids putting excessive
pressure on the mirror stem when installing and removing the RD. The top portion of
the mount should barely move when the two opposing forces are applied.
CLAMP
PLATE
ROTATING
ADJUSTMENT /
PLATE
PINCH
PLATE
WINDSHIELD
PAD
BOTTOM OF SPRING CLIP
IS PARALLEL WITH RD
2 - The bottom of the spring clip must be parallel with the
top of the RD to slide in and out. SLIDE THE RD ONTO
THE SPRING CLIP AS FAR AS IT WILL GO. Release the
trigger to secure the RD onto the mount. Before installing the
mount onto your rear view mirror, remove and install the RD a
few times so you can observe how the spring clip functions.
3 - This photo illustrates how the Hook fits into the recessed
area behind the mirror. This is just a reference photo as you
will not be able to see this during installation.
TIGHTEN CLAMP SCREWS
TO SECURE HOOK
ON MIRROR
4 - The two rotating adjustemnt screws can be used to move
the rotating adjustment plate left/right horizontally to point the
radar detector in a desired direction. The two clamp screws are
used to secure the mount onto the mirror as shown next in fig 5.
5 - Place the Windshield Pad onto the Silicone Pad. Position the mount
as shown above. Compress the Silicone Pad into the Windshield Pad as
you slide upwards into the recessed area behind the mirror. You will
hear the Hook snap into place when it is positioned correctly. Tighten
both clamp screws to secure hook and mount onto mirror.
lnnov tive Design And
Precision Manufacturing
PAGE 1 OF 2
BlendMount - US PATENT# 0625 ,580 S, 0656,811 S, 0653,980 S
0690,245 S, 0690,246 S, D690,247 Sand other patents pending