Owner's Manual

PART# BMX-3030
Blend fflaun-f-®
ESCORT PASSPORT MAX
LEFT HAND DR VE VEHICLE
1111111111111111111111111
Innovative Mounting Solutions
28028 34187 4
INSTALLATION INSTRUCTIONS FOR THE ESCORT PASSPORT AX RADAR DETECTOR
Your rear view mirror has minimal clearance between the back ide of the mirror and the mirror tem. It i
very Important that this mount is in talled correctly to ensure mirror adju tability i retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS OUNT
NOTE: For illustration purpo s, the mount and rear v w mirror hown in the in tructlon may look
lightly different then YOUR mount and rear view mirror.
BOTTOM OF SPRING CLIP
IS PARALLEL WITH RD
1 Th RELEASE Button on he radar d tector (RO) is NOT u with thi moun 2 • Th bo o of th prng c ip mu t b p r H I w·
To release the tension of the spring cl p, simply squeeze the TRIGGER and the back side
of the mount together. This will lower the bottom portion of the spring clip al owing you to
slide the RD on and off. When used property, the spring clip avoids putting excessive
pressure on the mirror stem when installing and remov~ng the RD . Th top port on of
th mount hould b r ly move wh n th two oppo Ing fore ai appl d.
top ofth RD to Id in do • SLIDE THE RD O TO
T E SPRING CLIP S F R S IT WILL GO . Release the
trigger to secure the RD onto the mount. Before installing the
mount onto your rear view mirror, remove and install the RD a
few times so you can observe how th spring clip function .
MID
SECTION
BODY
ASSEMBLY
3 - The BODY ASSEMBLY must be moved to gain access to the
CLAMP SCREW. Remove the two socket head screws as shown
above. Be sure to remove the lock washer with the top screw a ong with
the lock washer and flat wa her with the bottom screw. Loosen the
CLAMP SCREW so th re i nough clearance between the TOP and
MID SECTIONS to slide over the mirror stem.
lnnovativ Design And
· Precision Manufacturing
PIVOT
POINT
TOPANOMIO
SECTIONS MUST TOUCH
AT THE PIVOT POI T
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
4 • While sitting in the passenger seat, place the mount over the mirror
stem. Tighten the CLAMP SCREW until the mount starts to damp onto the
mirror stem. As you are tightening the clamp screw, MAKE SURE THE TOP
AND MIO SECTIONS TOUCH AT THE PIVOT POINT. If they do not touch
at the pivot p ·nt, YOU HAVE A INCO PATIBLE MIRROR TYPE FOR
THIS MOUNT. Position the mount as far forward as · twill go and parallel to
the bottom of the mirror before fully tigh ening.
PAGE 1 OF2
BlendMount - US PATENT# D625,580 S, 0656, 811 S, 0653,980 S
0690,245 S, D690,246 S, D690,247 S and other patents pending