Owner manual
Vercal Blind
Installaon Instrucons
Please follow these Installaon Instrucons
You will need a pencil, tape measure, drill, screwdriver, pliers, and appropriate fasteners.
Step 1: Choose the Correct Fastener
Step 2: Bracket Installaon (Before installing, review the chart below to conrm the correct # of brackets per blind)
Step 3: Headrail Installaon Step 4: Louver Installaon
1 ½” #8 Hex Head
Wood Screws (Included)
Alternave fasteners should be used for aluminum or
concrete installaons
(Not Included with Blinds)
Outside Mount (Figure A)
Standard wall mount installaon brackets are
adjustable and provide ½” to 1 ½” wall clearance.
Determine the height for the top of the bracket
(measured from the oor) by adding ½” to the blind
height including the headrail. When installed,
louvers will clear the oor by ½”.
Place the rst bracket directly over the corner of the
window with a maximum space of 30” between brackets. Adjust the bracket
so the louvers clear all obstrucons.
Inside Mount (Figure B or C)
Use mounng clips to secure headrail on ceiling or
inside mounts. The center of the mounng clips align
with the center of the louver carrier stem. Posion
the screws a minimum of 2 ¼” in front of the window
frame or any projecon.
Set mounng clips with a maximum space of 30”
apart from each other. Allow a minimum of ½”
clearance above sill or carpet.
Outside Mount
(Figure A)
Ceiling Mount
(Figure C)
Inside Mount
(Figure B)
Push the louver up into the carrier stem, then pull
slightly straight down to lock in place.
Use the following # of Installaon Brackets based on the Blind Width:
Up to 54” 54 -1/8” - 84” 84 ⅛” - 108” 108 ⅛” - 132” 132 ⅛” - 156” 156 ⅛” - 180”
2 3 4 5 6 7
Mount the installaon brackets on the headrail then snap in place, as
shown below. To remove headrail, simply push the release lip up with
a screwdriver.