User Manual

ManualsBrandsBlinds Chalet ManualsFor HomeEcoGreen Solar Screen Shades

ROLLER SHADES

Standard Installation Instructions - April 2007

1) Mount the Brackets

If the clutch is on the right end of the shade, attach the brackets to the window frame,

window molding, wall or ceiling, as shown below. If the clutch is on the left end of the

shade, reverse the bracket positions, left for right.

2) Install the Shade

a. Push the clutch straight onto the blade

of its bracket. The bottom of the clutch

should always point straight down.

b. Lower the lug of the end plug onto

the "V" of its bracket. The roller should

fit in the brackets securely, with just a

little play. Rotate the riveted retainer

portion to lock the lug in position.

The LUG

rests here.

The LUG

rests here.

The LUG rests

here.

After lug is set, rotate

retainer onto lug

After lug is set, rotate

retainer onto lug

After lug is

set, rotate

retainer

onto lug

To the Inside of the

window frame

To the wall or to the front of the

window molding

To the ceiling or to the top

of the window frame

3) Install the Tension Device

The tension device reduces the hazards of strangulation and entanglement of

young children and pets by limiting access to the control cord. Anchor the

tension device that is attached to the shade’s control cord to the window frame

or wall so that young children or pets cannot pull the cord around their necks.

a. Lower the shade.

b. Hold the tension device upright so the Warning Tag hangs straight down as

shown in diagram.

c. Position the tension device on the window frame or the wall so that the

tension device and control cord do not interfere with raising or lowering the

shade. The tension device should be installed without stretching or pulling

down on the control cord. Stretching the cord will cause excessive wear. Do not

twist or cross the control cord. If using stop balls, position the tension device

/4”

higher to allow the stop ball to pass thru the tension device.

d. Holding the tension device upright and in position as shown, insert and secure the

screw through the hole. The mounting screw must be secured into a solid surface

or molly.

Summary of content (4 pages)

PAGE 1
ROLLER SHADES Standard Installation Instructions - April 2007 1) Mount the Brackets If the clutch is on the right end of the shade, attach the brackets to the window frame, window molding, wall or ceiling, as shown below. If the clutch is on the left end of the shade, reverse the bracket positions, left for right. To the Inside of the window frame The LUG rests here. After lug is set, rotate retainer onto lug To the wall or to the front of the window molding The LUG rests here.
PAGE 2
4) Use the Control Cord to Operate the Shade Pulling gently on the cord in one direction raises the shade; pulling it in the other direction lowers it. On shades where the fabric rolls against the window, the front cord does the raising. On shades where the fabric rolls toward the room, the rear cord does the raising.
PAGE 3
) Install the Tension Device The tension device reduces the hazards of strangulation and entanglement of young children or pets by limiting access to the control cord. Anchor the tension device that is attached to the shade’s control cord to the window frame or wall so that young children or pets cannot pull the cord around their necks. a. Lower the shade. b. Hold the tension device upright so the warning tag hangs straight down as shown in diagram. c.
PAGE 4
2) Install the Shade Push the clutch straight onto the blade of its bracket. The bottom of the clutch should always point straight down, as shown in the illustration on page 3. Lower the lug of the end plug onto the V of its bracket. The roller should fit in the brackets securely, with just a little play. ATTACH FASCIA PANEL Attach the fascia by first hooking the top lip of the fascia panel onto the bracket as shown.