Cellular SlumberShade with energy saving blackout sidetracks Installation Instructions 152110 1/6/2011
BASICS Standard Brackets A few simple tools are required: - Measuring tape - Power drill, drill bits - Hex head and/or Phillips driver bit - Pencil Additional fasteners other than those sent with your shade may be required depending on the mounting surface. Wallboard and plaster require the use of anchors such as expansion or toggle bolts. Brick, tile or stone need special plugs and drill bits. Remember to always pre-drill holes in wood to avoid splitting.
Pull the tracks off the magnets and reinstall the shade. Continuous Loop and Cordless Brackets Position the headrail with the front lip (A) resting on the top hooks of all brackets. Make sure no fabric is pinched between the bracket and headrail. Push the bottom of the headrail firmly upwards and toward the window until the groove at the bottom of the headrail snaps into place, (B) as shown. Carefully slide the top of the track into the notch in the shade and push up. Let the track snap onto the magnet.
Step 5 IMPORTANT: FILL LIGHT GAPS The Cellular SlumberShade is designed to block light gaps with the energy saving blackout tracks. However, not all windows are perfectly square and light gaps may still exist. To block these light gaps, use the foam that is provided. We recommend placing foam on the sill directly behind the side tracks. Use the rest of the foam as needed to block light. foam OPERATION Standard Shades To lower or release shade, pull the cord inward toward the center of the shade.
Continuous Loop Shades TROUBLE SHOOTING Install Tension Device Problem: Shade is difficult to operate, especially near the top. Cause: Brackets and Side Track may not be properly aligned. Repair: Adjust brackets as necessary so the track is centered in the bottom rail end cap. The tension device reduces the hazards of strangulation and entanglement of young children by limiting access to the control cord. Attention! The cord tensioner must be installed to make the shade fully operable.