Owner Manual

PAGE
13
REMOTE ASSEMBLY AND
FREQUENCY SET UP
REMOTE ASSEBLY AND FREQUENCY SET UP
Locate the wireless remote control and insert (3x) AAA batteries (included). The
remote control is pre-programmed to work with the adjustable bed base. If you
have more than one adjustable bed base, each remote control and adjustable
bed base set should be pre-programmed to work separately.
If the remote control is not communicating with the bed (the base is not
responding by moving when the remote control is activated), please follow
the below steps:
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
To comply with the FCC RF exposure compliance requirements, no change
to the antenna or the device is permitted. Any change to the antenna or the
device could result in the device exceeding the RF exposure requirements and
void user’s authority to operate the device.
Radio Frequency: 2.4 GHz
Step 1: Unplug the power cord from the outlet. Wait about 5 seconds, then
plug it back into the outlet. Perform Step 2 within 10 seconds of doing Step 1.
Step 2:
On the back of the remote press and hold the PAIR button. The PAIR
button will illuminate blue and start ashing. When the PAIR button stops
ashing, the LED light on the control box will go out. Release the PAIR button.
The remote is now paired to the adjustable base.