User Manual

ManualsBrandsBLITZ ManualsEquipmentToyota Celica Compressor System

(C.58) Switch box

for the

lutch

(C.59) Relay box.

Tighten

together

with

this nut.

6mm round

terminal.

Location for the

Ground

(

brown

wire

)

Ignition ON (power supply)

Computer terminal arrangement figure

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No parts of this manual may be

reproduced, stored in retrieval systems, or transmitted in any way without prior written permission of Blitz Co., Ltd. (Japan)

Make a hole here

(

C.47

)

4 hose

(

C.57

)

Pressure

Connect the

(33) (C.57) Installation of the pressure sensor

① Fix the

(

C.57

)

pressure sensor using the

(C.65

)

lock tight at the location shown in the

figure.

② Install the (C.47) φ 4 hose that was

installed to the (C.39) nippleφ4-1/8PT at

the

(

C.2

)

intake manifold to the

(

C.57

)

pressure sensor and use the

(

C.65

)

lock

tight to tighten it.

※Cut the (C.47) φ4hose to an adequate

length.

③ Pass through the lid of the

(

C.63

)

computer

box by making a hole as shown in the figure.

④ Connect the (C.63) access computer’s

connector with the (C.57) pressure sensor’s

connector.

⑤ Install the lid of the computer box.

(34)Fix in place the (C.46) φ6 tube, (C.47) φ4

hose,

(

C.58

)

wiring for the clutch switch and

the

(

C.59

)

wiring for the relay harness using

the

(

C.65

)

lock tight so it does not get in

contact with moving or highly heated

components.

Online Manual Not For Resale Purposes