Manual

Page 9

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3 pin connector side of the

DMX cable to the output (female) 3 pin connector of

the ﬁ rst ﬁ xture.

2. Connect the end of the cable coming from the

ﬁ rst ﬁ xture which will have a (female) 3 pin connec-

tor to the input connector of the next ﬁ xture con-

sisting of a (male) 3 pin connector. Then, proceed

to connect from the output as stated above to the

input of the following ﬁ xture and so on.

A quick note: Often,

the setup for Master-

Slave and Standalone

operation requires that

the ﬁ rst ﬁ xture in the

chain be initialized for

this purpose via either

settings in the control

panel or DIP-switches.

Secondarily, the ﬁ xtures

that follow may also re-

quire a slave setting.

Check the “Operating Adjustments” section in this manual for com-

plete instructions for this type of setup and conﬁ guration.

Mounting & Rigging

This ﬁ xture may be mounted in any SAFE position provided there is

enough room for ventilation.

It is important never to obstruct the fan or vents pathway. Mount the

ﬁ xture using a suitable “C” or “O” type clamp. The clamp should be

rated to hold at least 10x the ﬁ xture’s weight to ensure structural sta-

bility. Do not mount to surfaces with unknown strength, and ensure

properly “rated” rigging is used when mounting ﬁ xutres overhead.

Adjust the angle of the ﬁ xture by loosening both knobs and tilting the

ﬁ xture. After ﬁ nding the desired position, retighten both knobs.

• When selecting installation location, take into consideration lamp

replacement access (if applicable) and routine maintenance.

• Safety cables MUST ALWAYS be used.

• Never mount in places where the ﬁ xture will be exposed to rain,

high humidity, extreme temperature changes or restricted ventilation.