User manual

Page 10

4. OPERATING ADJUSTMENTS

NOTE: After making any change, the unit will return to the correct mode in about 10 seconds.

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

1.) The default mode for the xture is DMX, which appears as Addr on the LED

Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to

choose a channel between 1 and 512. Press <ENTER> again to conrm.

2.) To change between 3 and 6 channel DMX mode, select ChNd, then press

<ENTER>. Select either 3Ch, 5Ch or 12Ch, then press <ENTER> again

to conrm.

Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):

1.) Use standard DMX cables to daisy chain your units together via the DMX con-

nector on the rear of the units.

2.) Choose a unit to function as the Master. Select MAST. The master unit must

be the rst unit. Finally, chain the units together using DMX cable.

Master SLNd then NASt to conrm.

3.) Select slave function by using the <UP>/<DOWN> keys to reach SLAV in

the Master/Auto menu on the slave units, and they will react in the same as the

Master.

Slave SLNd then SLAu to conrm.

NOTE: When a unit is set to slave and no master is connected, Stby will

appear on the LED display.

4.) On the master xture, use the <UP>/<DOWN> keys to reach SHND, which

allows you to select the Master/Slave mode.

Sound active SoUn then <ENTER> to conrm.

Auto mode CoLo then Auto, then <ENTER> to conrm.

Color preset CoLo then CoL 1 - CoL 31, <ENTER>

Color strobe StCo then 0-255 (Slowest <-.-> Fastest)

then CoL 1 - CoL 31, <ENTER>

To set a custom color in Master/Slave / Standalone Mode:

Using this function, you can select any color by adjusting the Red, Green, Blue, Amber and

White values from 0-255. You may also adjust the color balance of the xture.

Please note that modifying the values in this step will affect ALL modes, therefore

we recommend resetting all levels to their highest value (255) after using this

mode.

1.) Select NAnu from the control panel, then hit <ENTER>.

2.) Choose rEd, GrEE, bLuE, ANbE or Uhit, then hit <ENTER> to

conrm.

3.) Using the <UP>/<DOWN> keys, select the color you wish to display by

varying Red/Green/Blue intensity between 0 and 255, then hit <ENTER> to

conrm each color choice.

4.) Select Color preset mode as instructed above, then select CoL 15. then

<ENTER> to conrm.