User manual

Page 3

1. GETTING STARTED

What’s In The Box?

• 1 x Puck™ Q12+ Flat LED PAR Fixture

• 1x IEC Power Cord

• This Lovely User Manual

Getting It Out Of The Box

Congratulations on being completely and utterly qtastic! Now that

you’ve got The Puck™ Q12+ (or hopefully, Pucks!), you should careful-

ly unpack the box and check the contents to ensure that all parts are

present and in good condition. If anything looks as if it has been dam-

aged in transit, notify the shipper immediately and keep the packing

material for inspection. Again, please save the carton and all packing

materials. If a xture must be returned to the factory, it is important

that the xture be returned in the original factory box and packing.

Powering Up!

All xtures must be powered directly off a switched circuit and cannot

be run off a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel is used solely for a 0% to

100% switch.

AC Voltage Switch - Not all xtures have a voltage select switch, so

please verify that the xture you receive is suitable for your local pow-

er supply. See the label on the xture or refer to the xture’s speci-

cations chart for more information. A xture’s listed current rating is

its average current draw under normal conditions. Check the xture or

device carefully to make sure that if a voltage selection switch exists

that it is set to the correct line voltage you will use.

Warning! Verify that the voltage select switch on your unit

matches the line voltage applied. Damage to your xture may

result if the line voltage applied does not match the voltage

indicated on the voltage selector switch. All xtures must be

connected to circuits with a suitable Ground (Earthing).

Getting A Hold Of Us

If something is wrong, just give us a call or send an email.

We’ll be happy to help, honest.

Blizzard Lighting

W220 N1531 Jericho Ct. Suite E, Waukesha, WI 53186 USA

support@blizzardlighting.com

www.blizzardlighting.com

1.866.493.6025