Owner`s manual

Lit. No. B64090, Rev. 05 12 March 1, 2009
MOLDBOARD & A-FRAME ASSEMBLY
12-1/2"
Spring Loaded
Adjustable
Pivot Beam
Kickstand
1/8" Ground
Clearance
1. Position the pivot beam and A-frame near
the connecting points at the rear of the blade
between the two center support ribs. Insert one
3/4" x 3" clevis pin through each mounting hole
and secure with 1/4" x 1-1/2" cotter pin.
2. Mount the kickstand to the end of the pivot beam
(driver-side) using the 1/2" x 4-1/2" cap screw
provided. The spring, bushing and locknut are
located on the inside of the pivot beam. Review
the diagrams below and to the right. To pivot the
kickstand, pull the spring loaded leg out and rotate
it until the pin locks into place. Adjust the foot on
the stand arm so that the foot is 1/8" from the
ground when the A-frame is level and the A-frame
mount points are 12-1/2" from the ground. Tighten
both of the locknuts on the kickstand.