Owner`s manual

Lit. No. B64090, Rev. 05 24 March 1, 2009
ELECTRICAL INSTALLATION – VEHICLE SIDE
7. Remove the front signal lamp assembly from both
sides of the vehicle. On the driver's side, feed the
violet (turn lamp) and gray (run lamp) wires from
the main lighting harness through the opening
in the signal lamp housing. Use a test light or
ohmmeter to determine the proper wires in the
vehicle's electrical system to splice into. Position
one end of the turn or run lamp wire into the splice
lock connector, and attach the vehicle wire into
the opposite side. Complete the splice by pinching
both wires together and locking the connector.
Repeat the splice procedure for the remaining
wire.
8. Repeat Step 7 for passenger's side using the pink
(turn lamp) and gray (run lamp) wires.
9. Connect the vehicle headlamps to the main
lighting harness using a light conversion harness
kit. Due to differences in the construction of the
kits, and the various make and model vehicles
BLIZZARD
®
snowplows are installed on, a
light conversion kit is not packaged with your
snowplow. Contact your local BLIZZARD dealer to
obtain the appropriate conversion harness kit for
your vehicle.
10. Secure the braided harness to the vehicle.
Safely route all harnesses around the engine
components and attach them to the vehicle
with cable ties. Extend the snowplow headlamp
connectors, from the main lighting harness,
through the grille of the vehicle and position the
harness power plug and weather cap near the
bumper. Cable tie the plug to the vehicle bumper
or tow hook to keep the harness from hanging too
low.
11. Install the remainder of the vehicle wire harness to
the interior of the cab. Find an accessible location
for the snowplow headlamp toggle switch and
bracket under the dashboard. When choosing
a location for your switch, it should be mounted
in easy reach of the vehicle operator and not
restricting access to vehicle controls or vehicle
instrumentation. Do not mount the switch in areas
prohibited by the vehicle manufacturer for crash
worthiness. See the vehicle's body builder's book,
owner's manual or service manual for details. The
shaded areas in the illustration below show the
most commonly restricted areas.
Install the headlamp bracket using two self-drilling
screws. Insert the toggle switch through the
bracket and secure it with the hardware provided.
Plug both of the switch leads into the toggle
switch.
NOTE: Both terminals should be inserted into
the spades on the same side of the switch. One
terminal should be positioned in the middle
spade.
Plug both 2-pin connectors together and this
will connect the toggle switch to the vehicle wire
harness. See illustration below.
Vehicle
Harness
Green/Yellow
12" Long
To Control
DPDT
Toggle
Switch
.250
Receptacles
END VIEW
(looking at connector)
END VIEW
(looking at connector)
CAUTION
Do not alter, modify or install additional
components in shaded areas of the following
illustration. Failure to comply may interfere
with air bag deployment or cause injury to
operator in an accident.