Specifications

Installation
6
Oven Assembly
DOOR RELOCATION
The KCOĆ25E is shipped with the door hinged on
the right side. If left hand operation is necessary
use the following procedure to relocate the door.
1. Shut off the oven power switch.
2. Remove the door as follows:
a.) Loosen the two upper door bolts.
b.) Loosen the two lower door bolts. Remove
the top bolt.
c.) Slide the remaining lower door bolt up in
its slotted hole.
NOTE: The lower door pin attached to the
bolt will release from the bushing
in the unit frame.
d.) Tilt the door (with the 5/16" thick washer)
away from the unit.
e.) Lower the door so that the upper door pin
drops out of the bushing in the unit frame.
3. Relocate the hinge and catch parts as follows:
a.) Remove the trim plates located on the
frame opposite the door pins. The two
plates are attached with one screw each.
NOTE: This will expose the pin/bushing
holes for the alternate door locaĆ
tion.
b.) Move the two brass door bushings in the
unit frame to the alternate door pin/bushĆ
ing holes.
c.) Attach the trim plates to the frame over the
two holes where the bushings were.
Mounting holes are provided at the new
locations.
NOTE: Note that the upper trim plate has
a slotted air opening.
d.) Move the door catch plate located on the
upper door frame to the opposite side of
the oven cavity. Mounting holes are proĆ
vided at the new location for the catch
plate (two screws).
4. Reattach the door as follows:
a.) Attach the door to the unit at the relocated
bushings by reversing the steps above.
b.) Tighten the four door bolts hand tight only.
5. Relocate the handle and plate assembly on
the door as follows:
a.) Remove the four hex head screws which
attach the handle plates to the door.
b.) Twist the upper plate around the door
handle by at least 90_.
c.) Lower the handle and plate assembly out
of the door.
d.) Flip the handle and plate assembly 180_.
e.) Reattach the assembly by inserting the
roller latch plate into the opening at the
door top.
f.) Twist the lower plate around the door hanĆ
dle to its original mounting position.
g.) Reinstall the four screws through the hanĆ
dle plate into the door.
6. Adjust the door as follows:
a.) Close the door and check that the roller
latch secures the door tightly.
b.) Adjust the catch plate (by its slotted
mounting holes) if necessary.
7. Turn the unit on and verify that the door proxĆ
imity switch shuts off the fan when the door
opens.
Handle & Plate
Assembly
Door Bolt
Trim Plate
Door Catch
Under Overhand
Figure 4