Installation manual

Insert the short leg supports into the legs of the dishwasher.
1. Remove the adhesive tape (Figure A).
Place the trim strips on the front edge of the side walls
(Figure B).
Ý
Notice :
=
Make sure the dishwasher is plumb and notice dishwasher
can be placed with a small clearance under the counter
top.
Adjust the front foot level with the adjusting wrench to balance
and raise the dishwasher to the enclosure height.
Adjust the rear foot level with a screwdriver to balance and
raise the dishwasher to the enclosure height.
=
Turning the screwdriver in the direction of the black arrows
will bring the dishwasher back feet up.
=
Turning the screwdriver in the direction of the white arrows
will take the dishwasher rear feet down.
6.3. ADJUSTING HEIGHT
6.4 INSTALLING THE SIDE TRIM STRIPS
Figure A
7
Figure B
1
1
/
8

(50mm)
1
1
/
8

(50mm)
Supplied (4)
T20
(861
mm - 911mm)
33
7
/
8
- 35
7
/
8
