Installation manual

Remove the junction box cover by removing the screw as

shown in the figure. They will be reinstalled later.

WARNING

Installation should be performed by a qualified installer.

Work by unqualified persons could be dangerous and

may void the warranty.

If the dishwasher is installed in a location that

experiences freezing temperatures (e.g. in a vacation

home, cabin etc.), you must drain all the water from the

dishwasher's interior. Water system ruptures that occur

as a result of freezing are not covered by warranty.

CAUTION

Do not over tighten the 90° elbow. Doing so may damage

the water inlet valve and cause a water leak.

6.5 PREPARING THE WATER CONNECTION (A)

6.5.1 INSTALLING THE 90° ELBOW FITTING (B)

6.5.2 JUNCTION BOX PREPARATION (C)

Install an easily accessible shut-off valve (not supplied) in

the water supply line. All solder connections must be made

before the water line is connected to the dishwashers water

inlet valve. Water can also be supplied to the dishwasher

by using a flexible braided hose line.

Check with your plumbing supply sources for the proper

hose and 90° elbow and necessary fittings for the water

supply line.

This material is not supplied, and must be

purchased separately.

If the water supply line is to be copper tubing, make certain

that the elbow has a compression fitting. Apply Teflon tape

or other pipe sealant when required. Orient the water supply

connection on the left side as shown in the figure so the

water line can be easily pulled underneath or on the side of

the dishwasher.